Always there to help you Register your product and get support at www.philips.
Contents 1 Safety 2 2 Your Bluetooth Adapter 3 3 3 3 Before use 4 4 5 4 Use the Bluetooth adapter 6 6 7 7 7 5 Product information 8 8 8 8 6 Troubleshooting 9 9 9 Introduction What's in the box Connect audio cables Connect power Connect a Bluetooth device Disconnect a device Reconnect a device Clear pairing history Amplifier Bluetooth General information General About Bluetooth device 7 Notice Compliance Care of the environment Trademark notice Copyright 10 10 10 10 11 EN 1
1 Safety Read these instructions. Follow all instructions. Do not use this apparatus near water. Do not place near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. Use only power supplies listed in the user manual.
2 Your Bluetooth Adapter Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www. philips.com. If you contact the Consumer Care, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the product. Write the numbers here: Model No. __________________________ Serial No.
3 Before use Always follow the instructions in this chapter in sequence. Connect a coaxial audio cable between • the COAXIAL OUT socket on the Bluetooth adapter, and • the coaxial audio input socket on your Hi-Fi system. Note Connect audio cables There are three ways to connect the Bluetooth adapter to your Hi-Fi system. Select one fit for the Hi-Fi system. Option 1: Connect through the AUX OUT socket •• Make sure that no cable is plugged in the AUX OUT socket.
Connect power Caution •• Risk of product damage! Make sure that the power supply voltage matches the voltage printed on the bottom of the unit. •• Risk of electric shock! Hold the plug securely when unplugging the device. Note •• The type plate is located on the bottom of the Bluetooth adaptor. Connect the power adaptor to: • the DC IN socket at the back of the Bluetooth adapter. • the wall outlet.
4 Use the Bluetooth adapter Connect the Bluetooth adapter to your Hi-Fi system with audio cable, and then you can stream audio from your Bluetooth device to the Hi-Fi system via Bluetooth. Enter Bluetooth pairing mode • • When connected to power, the Bluetooth adapter tries to connect with the last paired device. If no device is paired, the Bluetooth adapter enters Bluetooth pairing mode automatically. Afterwards press and hold for 2 seconds to enter Bluetooth pairing mode.
Connect a fourth Bluetooth device • • Connect the fourth device manually (see 'Connect manually' on page 6). Press and hold for 2 seconds to switch AEA2700 to pairing mode, and then connect the fourth Bluetooth device by NFC (see 'Connect easily by NFC' on page 6). »» Once the fourth device is connected, the earliest connected device will be replaced, if there is no music play. Disconnect a device • • On your device, disable the Bluetooth connection with this product.
5 Product information General information AC Power Note •• Product information is subject to change without prior notice. Amplifier Output Voltage Frequency Response Signal to Noise Ratio Total Harmonic Distortion 1000 mV RMS 20 Hz - 20 kHz, ±3 dB > 62 dB <1% Bluetooth Standard Frequency Band Range 8 EN Bluetooth Standard Version 3.0 2.402~2.
6 Troubleshooting Warning •• Never remove the casing of this product. To keep the warranty valid, never try to repair the product yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available. Cannot connect with the device.
7 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Compliance This product complies with the radio interference requirements of the European Community. Hereby, WOOX Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can find the Declaration of Conformity on www.philips.com/ support.
Copyright 2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.” Specifications are subject to change without notice. WOOX reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.
Specifications are subject to change without notice. 2014 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. AEA2700_12_UM_V1.