User manual

ManualsBrandsPHILIPS ManualsInterior DecoratingLED decorative light LED 8 W Bloom Black

User Manual LivingColors Bloom

Unpacking and Installing

If you unpack a LivingColors, the product is already linked to the remote control. You only need to plug it into the power system,

put the batteries into the remote control and start the experience!

Step 1: Place your LivingColors in a selected location on a at and stable surface and direct it towards the wall

(the optimal distance is 50 cm).

Step 2: Plug your LivingColors into the power system.

Step 3: Insert the two AAA-batteries by sliding open the battery compartment (+ and – as indicated) on the back

of the remote control.

Getting started with your LivingColors

Summary of content (7 pages)

PAGE 1
User Manual LivingColors Bloom Getting started with your LivingColors Unpacking and Installing If you unpack a LivingColors, the product is already linked to the remote control. You only need to plug it into the power system, put the batteries into the remote control and start the experience! = + + + Step 1: Place your LivingColors in a selected location on a flat and stable surface and direct it towards the wall (the optimal distance is 50 cm). Step 2: Plug your LivingColors into the power system.
PAGE 2
Basic functionality Switch the LivingColors “On” or “Off”: Your LivingColors can be switched “On” and “Off ” by using the “I”- and “0”-button on the remote control. If you switch the LivingColors “Off ”, it will remember your last setting for the next time you use it. Colour selection: To let your LivingColors change to whatever colour you like, simply rotate the colour wheel (rotary wheel at the centre of the remote control) until you have found the right colour.
PAGE 3
Colour intensity (saturation): If you want to add more white to your current colour or make your colour intense (saturated) again, you can easily change the colour intensity (saturation). Just press the colour wheel on the left (more white) or right (more colour) position. If you keep pressing on the left position, you will ultimately reach white. Discovering your LivingColors Extended functionality Automatic Colour Change Mode: You can also let your LivingColors change colours automatically.
PAGE 4
Favourite Buttons: With your LivingColors you can store your two favourite colours for easy recall. To store your favourite colour, first select it using the colour wheel (and dimming/colour intensity) on the remote control. Then press and hold one of the Favourite Buttons until the LED indicator (hidden underneath the intensity up symbol) blinks (this will take +/- 5 seconds). Your favourite colour is now stored under the Favourite Button (1 or 2) that you have pressed.
PAGE 5
Disconnecting multiple Philips LivingColors (optional) If you connect another remote control to the same luminaire, it will be automatically disconnected from the first remote control (unless the two remotes were connected first - see further). Alternatively, you can disconnect a remote control from a luminaire as follows: Hold the remote control against the Philips logo on the lens of the product, then press and hold the “0”-button. The product will flash 3 times.
PAGE 6
Step 3: You still need to connect the additional remote to the LivingColors. If you have two round remotes, you can do it easily by repeating the above action (bring two remotes close, then press on “I” until they stop blinking intermittently). This action needs to be done directly after connection of the additional remote control. The additional remote is now connected to the same lights as the first remote control. 10 sec.
PAGE 7
Solution 3: Reset the remote control Open the remote control’s battery compartment and press the RESET button for a few seconds (e.g. with a paper clip). Make sure that the batteries are in. After this action, you need to reconnect your LivingColors to the remote control.