Installation Guide

Needed:
RESCREENING instructions
Spline (see front of product label to determine correct spline diameter)
spline roller tool scissors utility knife
heavy duty tape at work surface
Place screen frame on a at surface.
Remove any existing spline. Tape
outside edges of frame to the surface.
Do not tape over the spline groove.
1
Lay screen fabric over frame, align
squarely and overlap 1/2” on all sides.
2
Using the spline tool, roll the fabric
into the screen frame groove holding
fabric straight while rolling. The spline
should be pressed securely in the
groove and in each frame corner. It
may be necessary to push the spline
into each corner using the utility knife
or a screwdriver.
3
Tips
• Polyester screening is
a thick material which
requires a spline
diameter that is one
size smaller than is
used for berglass
screening.
*Examples:
• PetScreen®,
• SunTex®, and
• TuffScreen®
• When rescreening
aluminum wire mesh,
gently roll the fabric
in the groove with the
smooth end of the
spline roller tool and
nish securing it with
the grooved end of
the roller tool..
4
Fiberglass & Aluminum Fabrication
Use utility knife to trim excess spline
and screen from frame, making sure
to cut toward outside edge of spline
groove to prevent damage to the newly
installed fabric.