Instructions / Assembly

Troubleshooting
21
ENJOY YOUR CAPTIVA DESIGNS
Problem
Possible
Cause
Solution
If the above solutions do not solve your problem, or you need to replace the accessories,
please contact our Customer Service.
There is a smell
of gas
Leak in the gas system
Close the cylinder valve immediately.
Prevent any ame or spark formation(do
not switch on any electrical appliances).
Tighten all connections on the gas system.
Check all components of the gas system
for visible damage replace defective parts
with original spare parts.
Check for leaks using a leak detector.
Burner does
not ignite
Gas cylinder is empty Replace the gas cylinder.
Cylinder valve is closed Open cylinder valve.
The nozzle on the
adjusting element(behind
front panel)is not inserted
into the burner hose
Visual inspection,if necessary adjust nozzle
and connection hose.
The igniter cable is not
on the igniter
Conduct a visual inspection,connect if
necessary.
Battery of the electronic
ignition is out
Replace battery.
Distance between the
spark plug and gas outlets
on the burner is incorrect
Visual inspection;correct if necessary.
Nozzle on adjusting
element(underneath
front panel) is blocked
Clean the adjuster jet with a needle.
Other gas system
blocked
The gas system should be cleaned by a
specialist.
Temperature on
grill griddle
too low
Preheating was too short Close the lid and set the ame valve to max.
Gas outlets on the burner
are blocked
Remove blockage from burner.
Strong are-up Fatty foods
Remove any large areas of fat prior to
barbecuing or place the meat on a grill
griddle plate or reduce the barbecue
temperature.
Popping or
bubbling noise
Flashback caused by
blockages in the burner
Close the cylinder valve immediately.
Wait ve minutes and then switch the
barbecue back on.
If the malfunction reoccurs,disassemble
and clean the burner.