Instructions / Assembly

Operation Instructions

CHECKING FOR LEAKS

After all connection are made, check all connections and ttings on the LP gas tank valve, gas hose gas hose

and regulator for leaks with a water and soap solution.

To prevent re or explosion while testing for a leak:

• Always perform leak test prior to lighting the grill.

• Do not smoke while testing for a leak.

• Always perform leak tests outdoors in a well-ventilated area.

• Do not use the grill until any and all leaks are corrected.

• Do not use any source of ame while testing for leaks.

• If you are unable to correct a leak, disconnect the propane supply and call a gas appliance service dealer.

Leak detecting agent:

You can locate any leaks in the gas system using a leak detection agent. These are available at DIY shops or

from liquid gas suppliers. Please follow the operating instructions of the leak detection agent.

PERFORM LEAK TEST

• Prepare leak test solution by 50/50 ratio of liquid dish soap and water.

Total solution required is approximately 2 - 3 ounces (70 - 90 ml).

Put leak test solution in a spray bottle.

• Ensure all control knobs are in the OFF position.

• Connect the gas hose to the gas supply.

• Open the LP gas tank valve.

• Spray leak test solution on all gas carrying connections an of applied test solution indicates a gas leak. If

leaks are detected or you smell or hear gas, shut off the gas supply valve immediately and repair or replace

the defective part. Do not use the grill until all leaks are corrected.

CAUTION:

Only use the regulator and hose assembly provided! If a replacement is necessary, please call our

customer service center. Do not use replacement parts that are not intended for this grill.

WARNING:

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT

FIRE, DAMAGE AND/OR INJURY.

ENJOY YOUR CAPTIVA DESIGNS