Manual

ENGLISH
ENGLISH
ENGLISH
14
12
13
11
15
12 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Faucet Inlets (12B), approximately three inches apart.
Connect water Supply Lines (12A) to Faucet Inlets (12B). Hot water supply line goes
to hot inlet fi tting indicated by red tag (12C). (Supply lines not included). Follow
manufacturer’s instructions when installing supply lines.
13 SECURING INLET LINES
Do not cross Pullout Hose Connection (13A) with Inlet Supply Tubes (13B) to avoid
binding, jamming and interference with the movement of the Pullout Hose (13A).
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink .
15 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may have collected
in the water lines, it will be necessary to fl ush the faucet. Lift the faucet handle (15A) up
to the full on position. Run water for one minute. Repeat in hot and cold positions.
Note: For valve functions (see step 18).
11 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (11A), located on the end of the Pull-
Out Hose (11B) fi rmly upward onto the Receiving Tube (11C), until unable to push any
further. Pull down on the Quick Connector (11A). If the housing and the Inner Collet
(11D) separate slightly but do not pull off, the Receiving Tube (11C) quick connect is
secure.
4
HOT
COLD
11A
12A
13B
11B
11C
11A
11C
11D
11A
11C
12A
12B
12C
12B
13B
13A
15A