For The ON-THE-GO Pet™ INSTRUCTION MANUAL EASY STEP III EXTRA WIDE PG9730XLCH/PG9730XLTN To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service.
Straight Side ASSEMBLY INSTRUCTIONS Make sure rubber grippers are on the bottom. E B Step 1 With rubber grippers on the bottom, place right panel, part (B) on floor with PET GEAR Logo facing the floor and insert top stair, part (E). Keep the STRAIGHT SIDE toward the back and rug facing the top. Make sure there are no gaps between parts after inserted. (If inserting part is difficult put a little dish soap on doweled end before inserting.) C Step 2 Insert riser, part (C).
ASSEMBLY INSTRUCTIONS Step 5 Insert bottom stair, part (F). Note the CURVED SIDE direction. Make sure there are no gaps between parts after inserting. Step 6 Insert riser, part (C). Make sure there are no gaps between parts after inserting. F Curved Side Step 7 Insert center support panel, part (G), in middle row of holes. Make sure there are no gaps between parts after inserting.
ASSEMBLY INSTRUCTIONS Step 8 Insert dowel, part (D), into hole and slide into notch on center support panel. Insert Dowel D Notch G D A Step 9 Attach left panel, part (A). Align all holes before pushing panel down. Make sure there are no gaps between parts after inserting.
WARNING! FOR PETS ONLY. Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death. REPLACEMENT PARTS Use only PET GEAR replacement parts.
