Installation Guide

6
TRADITIONAL FLOOR MOUNT TUB FAUCET (cont.)
Tub
See Step 4
X
T-FB1
U-FRSR
U-SBRC
Floor Flange
(26)
Decorative
Flange (25)
Step 4 Drill (2) 1-1/8” holes into oor on 8” centers
for hot and cold water supplies. If using U-SBRC
support brace, water supply holes must be drilled
at 3-3/4” from drain outlet (center to center). If not
using support brace, holes should be drilled at
2-1/2” mimimum to 3-1/2” maximum from drain outlet
(center to center).
Step 5 If desired, attach U-SBRC support bracket
to risers. See page 20. (Tub model Newcastle does
not have an exposed drain so support brace will not
be used)
Step 6 Slide #25 decorative escutcheon onto
bottom of risers U-FRSR and push part way up.
Screw #26 oor ange onto threaded portion of
each riser until it stops.
Step 7 Insert risers into hole in oor and secure
oor anges with appropriate screws/bolts for your
ooring type. (Hardware not included)
Step 8 Slide decorative escutcheon down to cover
oor ange.
Step 9 Tighten optional support bracket to risers
and drain
Step 10 Attach small end of #18 handshower hose
with #28 washer to outlet on side of #1 handshower
holder.
Step 11 Attach large end of #18 handshower hose
with #28 washer to #6 handshower and place in #1
holder.
Step 12 Connect preferred ½” pipe (supplied by
installer) into female threaded riser U-FRSR from
under ooring. Make hot/cold water connections.
Turn on water and check all connections for leaks.
18
6
small end
large end
1
28
28
8"
Dimension X
If using support bracket 3-3/4”
If NOT using support bracket 2-1/2” TO 3-1/2”
NOTE: When using the
U-SBRC support brace
it must be installed onto
faucet risers prior to
securing to oor
Side View End View