Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
10
System Menu
The System menu provides access to the General Settings, Backup and Restore, Firmware, OSDi,
Snapshot Viewer, Storage Management, and Diagnostics pages.
Configuring General Settings
1. Device Name: Configure the name for your device. Names can contain up to 63 alphanumeric
characters. At least one character in the host name must be a letter.
2. Enable LEDs: Enable or turn off LED camera lights.
3. Power Priority: Select a priority power supply as either 24v or Power over Ethernet (PoE).
4. Click Save.
Configuring Time Settings
You can set your camera to discover a network time server (NTP) automatically, manually provide the
address of your network time server, or select no time server.
1. Select your time server setting:
l Auto: Allows your camera to discover and synchronize with your network time server (over
IPv4 or IPv6).
l Manual: Requires you to provide the address of your network time server.
l None: Camera date format defaults to mm/dd/1970.
2. Select the TimeZone.
3. Click Save.
Configuring GPSSettings
Use the GPS Settings option to establish the camera’s GPS location.
1. Manually enter the Latitude, Longitude, and Elevation of the camera.
2. Click Save.
Generating a System Log
If technical difficulties occur, a system log might help Pelco Product Support troubleshoot problems with
your camera. You can contact Pelco Product Support at 1-800-289-9100 (USA and Canada) or +1-559-292-
1981 (international).
1. Select General Settings from the System menu.
2. Click Generate System Log.
3. Select the location in which to save the log file.
4. Click Save.
Restarting the Camera
If you are recording video from your camera, restarting the camera will cause a gap in video recording. It is
important that you schedule maintenance before restarting the camera.
1. Select General Settings from the System menu.
2. Click Reboot Camera.