User Manual

31
SNMP Configuration
WARNING: The Simple Network Management Protocol (SNMP) settings are advanced controls. Consult your network
administrator to obtain the required information to configure SNMP settings.
 No SNMP Server
None disables the SNMP configuration and is the default setting.
 CONFIGURING SNMP V2C
1. Select V2c as the SNMP Version.
2. Type the community name in both the Read and Write Community String box. The default name for each is “public”
and “private” respectively.
3. Configure the Trap Configuration settings.
 Address: Type the host name or IP address of the recipient of the trap message.
 Community String: Type the name of the community that should receive the trap message.
4. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered
without saving it.
 CONFIGURING SNMP V3
1. Select V3 as the SNMP Version.
2. Enter the SNMP user name in the SNMP User field.
3. Select the encryption algorithm for authentication from the Authentication drop-down menu: None, MD5, or SHA.
If you use authentication method MD5 or SHA, type a password in the text box to the right of the selected
Authentication encryption.
4. Select the privacy encryption algorithm setting from the Privacy drop-down menu: None, DES, or AES. If you use
privacy method DES or AES, type a password in the text box to the right of the selected Privacy encryption.
5. Configure the address for the Trap Configuration. The Address is the host name or IP address of the recipient of
the trap message.
6. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered
without saving it.
NOTE: SNMP V2c and SNMP V3 configuration settings are independent of each other, but only one SNMP version can
be active at a time.