Installation Manual

13 of 41

ISSUED: 06-05-06 SHEET #: 202-9141-13 (2014-03-14)

FOR PLAV60 ONLY:

Position of display may be adjusted vertically up to .79" in

each direction by doing the following:

• To lower display, turn socket screw shown in ﬁ gure 10.1

clockwise with 10mm allen wrench (V).

• To raise display, turn socket screw shown in ﬁ gure 10.1

counterclockwise with 10mm allen wrench (V).

If it is too difﬁ cult to adjust roll of plasma, loosen

screws shown in ﬁ gure 9.1 using a phillips screw-

driver.

IMPORTANT! Do not loosen or tighten screws

more than 1/8 turn.

Depending on the speciﬁ c size & weight of the plas-

ma, articulating swing arm may be angled at different

positions, causing plasma to appear to lean sideways

at different articulating positions. Tilt-roll assembly (B)

allows plasma to be manually adjusted, so plasma

can be horizontal at all positions. To adjust, gently

rotate plasma by hand to desired position.

9-1

SOCKET

SCREW

ﬁ g. 10.1

ﬁ g. 9.1

ROLL

ADJUSTMENT

SCREWS

ARTICULATING

ARM

PLASMA

All other brand and product names are trademarks or registered trademarks of their respective owners.