Datasheet

Table 1-2 Description of function keys on front panel
Function key
Function description
FREQ
Set informations like center frequency, start frequency and end frequency
etc.
SPAN
Set the frequency range of sweep.
AMPT
Set parameters like reference level, RF attenuator, scale, Y-axis units etc.
Set level offset, the largest mixer and input impedance. Used to perform
automatic calibration, automatic range and turn on the preamplifier.
BW
Set resolution bandwidth (RBW) and vedio bandwidth (VBW) and V/R
ratio.
Sweep
Set parameters like sweep time, mode etc.
Trigger
Set informations about trigger
Single
Set “single” trigger of the instrument
Display
Set informations about screen display
Auto Tune
Auto tune of full frequency range
Marker
Read amplide, frequency or sweep time etc. of each point on trace
through the marker
Marker—>
Set other system paraters of the instrument with current marker value
Freq Count
Set parameters like frequency count, resolution etc.
Peak Search
Unfold setting menu of peak search, and execute peak search function
simultaneously
Demod
Config demodulation function **
Meas
Select and control measurement function **.
CAL
Set information about the auto calibration of the instrument .
Trace
Set parameters of trace.
Detector
Set detection mode of detector.
System Setup
Set parmaters of system.
Triger
Set information about trigger.
Save
File save and read function.
Recall
Recall saved data and information.
Preset
Reset system to factory default state or user-defined state.
Note：
*The function is only applicable for the unit selected with according options.
-8-