Installation Instructions

ManualsBrandsPatriot Lighting ManualsLighting & Ceiling FansClermont Brushed Pewter And Textured Black Outdoor Wall Light

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

SKU Number: 356-3839

OUTDOOR WALL LANTERN

Model Number: DN8105

PACKAGE CONTENTS

Page 1 of 4

200717

HARDWARE CONTENTS Note: Hardware not shown actual size.

Mounting Strap Unit

Mounting Screw

Wire Connector

End Cap

Rubber Pad

AA BB

60W Type T10 Bulb

(included)

Summary of content (4 pages)

PAGE 1
SKU Number: 356-3839 OUTDOOR WALL LANTERN Model Number: DN8105 Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS A HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS (continued) 3. Pull out the source wires from the 3 AA outlet box. Make wire connections using wire connectors (CC) as follows: • Connect the hot wire (usually black insulation) from the fixture to the black wire from the power CC source. • Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. • Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap unit (AA) with the green grounding screw.
PAGE 4
CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth. TROUBLESHOOTING 1) The light does not come on at all: a) Make sure the wall switch and circuit breaker are on. b) Make sure the wiring is correct. 2) Fuse blows or circuit trips when light is turned on. a) Check for crossed wires, ensure wiring is correct. If unable to fix any of the above issues, please consult a certified electrician.