52” SONESTA III CEILING FAN Owner’s Manual Model #20686 (355-0661) If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-459-3267, 9 a.m.- 5 p.m. Central time.
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: 1 2 PACKAGE CONTENTS 16 3 4 5 6 7 17 18 2. Canopy 14. Shade (x3) 3. Canopy Cover 15. E26-base LED Bulb (x3) 6. Yoke Cover 20 9 7. Set Screw (x2) 8. Closemount Screw (x3) 21 10 11 13 13. Light Kit 4. Mounting Bracket Screw 16. Rubber Gasket (x4) 17. Downrod 5. Mounting Bracket 18. Downrod Clip 19 8 1. Trim Ring 9. Motor Assembly 12 10.
DIMENSION REFERENCE E D B C A A. 19.72 in. B. 12.57 in. C. 13.82 in. D. 11.12 E. 5.13 MOUNTING OPTIONS Triple Mount Drawing Closemount Downrod Mount Slope Ceiling Mount (Up to 16 degrees) Choose one of the following mounting options: Closemount method is best suited for ceilings lower than 8 feet. It does not utilize the downrod. Downrod Mount is best suited for ceilings 8 ft. or higher. For taller ceilings you may want to use a longer downrod (not included).
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. Do not insert foreign objects in between rotating fan blades.
ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. 1 Mounting Bracket Screw 2 2. Remove the canopy from the mounting bracket by removing the two mounting bracket screws from the round holes in the canopy. Then, loosen the other two mounting bracket screws from the J-shaped slots. Retain the mounting bracket screws for later. Install the mounting bracket to the outlet box (not included) using the screws and washers provided with the outlet box.
ASSEMBLY INSTRUCTIONS 5. Feed the wires coming from the yoke through the yoke cover, trim ring, canopy, downrod and rubber gasket. Slide the rubber gasket down until it covers the top edge of the downrod. Rubber Gasket Downrod Canopy Trim Ring 5 Yoke Cover Yoke Downrod Yoke Downrod Clip Downrod Pin Set Screw 6 7. Lift the downrod into the mounting bracket. Rotate the downrod until the tab in the mounting bracket is seated in the slot in the downrod ball. Mounting Bracket Tab Slot Downrod 6.
ASSEMBLY INSTRUCTIONS Mounting Bracket Screw J-shaped Slot Round Hole 9 Canopy Trim Ring Motor Motor Block 10 9. Raise the canopy, align the two mounting bracket screws with the J-shaped slots in the canopy. Then turn the canopy clockwise until the mounting bracket screws are completely engaged in the J-shaped slots. Install the two previously removed mounting bracket screws into the round holes. Securely tighten all four mounting bracket screws.
ASSEMBLY INSTRUCTIONS Adapter Plate 13 13. Remove one and loosen the other two adapter plate screws on the adapter plate. Lift the fitter plate onto the two adapter plate screws and turn in a clockwise direction. Then insert the previously removed adapter plate screw into the round hole. Tighten all three screws to secure the fitter plate. Adapter Plate Screw Fitter Plate Screw Light Kit 9-pin Connectors 14 14. Remove the three fitter plate screws from the top edge of the light kit.
ASSEMBLY INSTRUCTIONS 17. Attach the pull chain extensions to the pull chains. 17 Assembly is complete. Restore the power at the main fuse or circuit breaker. Pull Chain Extension OPERATING INSTRUCTIONS Reverse Switch 1 2 Light Pull Chain 1. Use the fan reverse switch for seasonal performance. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in winter without feeling a difference in your comfort.
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-459-3267, 9 a.m.- 5 p.m. Central time. PROBLEM SUGGESTED REMEDY 1. Fan does not start 1.
LIMITED LIFETIME WARRANTY To obtain Service, please contact the Service Department: 1-877-459-3267, 9 a.m.- 5 p.m. central time.
