LIMITED LIFETIME WARRANTY To obtain Service, please contact or call PATRIOT LIGHTING® Service Department: 1-800-887-6326, 9 a.m.5 p.m. central time. Model No.
Package Contents: Unpack your fan and check the contents. You should have the following items. 1.) Hanger Bracket 2.) Canopy 3.) Down rod Set (Included Hanger Ball, 6" Down rod, Hanger Pin & Lock Pin) 4.) Down rod Stand Cover 5.) Fan Motor Assembly 6.) Fan Blades (PCS) 7.) Blade Bracket (5 PCS) 8.) Connect Plate of Light Kit. 9) Light Kit 10.) Remote Controller Set (Includes Receiver & Transmitter & Wire Connectors & Battery) 11.) Assembly Kit 12.) Blade Balancing Kit 13.) Installation Instructions 14.
Exploded View Detail -Hanger Bracket Hanger Ball Down rod Canopy Lock Pin = Hanger Pin downtrodden Stand Cover Fan Motor Assembly . : " Blade Bracket Connect Plate of Light Kit Light Kit LED Bulb N\ Dual Mount Drawing Down rod Mount Slope Ceiling Mount (Up to 23 degrees) “Patriot . LIGHTING.
Safety Instructions READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN TO INSTALL THE FAN AND SAVE INSTRUCTIONS. ®All set screws of the fan must be checked and re tightened where necessary before installation. ® To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning the fan. Do not insert foreign objects between rotating fan blades.
INSTALLATION INSTRUCTIONS IMPORTANT: @ BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN. ® SAVE ALL INSTRUCTIONS. NOTE: The fan weight is 19. 84 Ibs (9.0kgs). Be sure the outlet box you are using is securely attached to the building structure and can support the full weight of the fan. Failing to do so can result in serious injury.
There is a code switch in the transmitter and %IP receiver. This "DIP Switch" is a 4 key units gHE! {Fig.8). All keys were set at "ON" position in the beginning. Set the keys fo a different code. Make sure the same numbered keys are switched "ON" for both DIP switches T3 (Fig.Ba). If the remote controlled fans are g Installed than one or the frequency Is interfered, the fan may function abnormally. Code example: 1-ON 2-OFF 3-ON 4-OFF on both DIP Switches.
Attach the canopy to the hanger bracket, Tighten blades to blade brackets by and then secure it with four screws and washers. Install fan light WARNING: Rotate the moor o remove the motor screws using blade screws and washers. and washers from fan motor assembly. Secure blade brackets to the motor with washers and motor screws Foreshorten installing blade brackets to the motor, please remove the plastic Inserts.
m Install the battery (9V, Included) to the transmitter. * Press "HI™ button to turn on the fan at high speed. ot e * Press "MED" button to tum the fan in medium speed. LIGHT —1 @D DIMMER * Crass "LOW" button to tum the fan in low speed. ON/OFF < OH—FAN OFF | Press "FAN OFF" button to tum off the fan. © * Press "LIGHT ON /OFF" button to tum on or tum off the light FS * Press and hold the "DIMMER" button o dim or brighten lights to the desired level and release, and the brightness elev! will be memorized.
+| Fora single switch Follow these steps: & Connect the white (neutral) Wire from motor to the whits| neutral) wire from the fortieth box with a wire cannelloni, ) [Connect free [Connect the back (hot) wire % ground wires (Green I(This Is for fan control} and bite lor bare copper} coming Wire (This is for light control) from from loutish bax, motor to the black (hot) wire from {down rod and hanging fortieth box with a wire connector. bracket with a wire connector.
Trouble Shooting Guide If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. If you experience any faults, please check this Trouble Shooting Guide. If a problem cannot be remedied or you are experiencing difficulty in installation, please call our Customer Service Department (1-800-887-6326). PROBLEM SUGGESTED REMEDY 1. If fan does not start: Check main and branch circuit fuses or circuit breakers. .
DYNAMIC BLADE BALANCING KIT YARDSTICK -~ (——BALANCING WEIGHT ! CENTER LINE MEASURING & POINT P @\ T Encounter. \ CLOCKWISE PLASTIC CLIP PREFACE Your ceiling fan may sometimes have wobbling problems when operating due to irregularity in the blades or the blade brackets. Improper assembly in the mounting system may cause some additional problems. This balancing kit can be used to fix wobbling problems. DYNAMIC BLADE BALANCING KIT FOR CEILING FANS 1.