Instruction Manual

1. Turn on the transmitter and receiver.
2. Press the the “power” button once again, the red light
will light up and you will hear “Beep”
3. Press the ”Static Shock”button on the transmitter, and
you will hear “Beep” again which means this product has
been matched complete. Use the test bulb to test the
shock.
Note: The level of static shock can not be 0 during the test.
Operation Steps:
How to use two receivers at the same time:
1. Press the "1/3" button to select the channel 1
to be paired, then follow the "operation steps" to
pair it.
2. Press the "1/3" button to select channel 2 to
pair, then follow the "operation steps" to pair it.
3
4. When the receiver does not work, it enters sleep
mode after 2 minutes. Press any button on the remote
control to reactivate it.