User Manual

- 119 -
PATON ProMIG DC MMA/TIG/MIG/MAG
2) [t.Pr] pre-purge time = 0.1 sec (by default)
a) 0.1 ... 25.0 sec (change step 0.1 sec)
3) [t.Po] gas post-purge time = 1.5 sec (by default)
a) 0.1 ... 25.0 sec (change step 0.1 sec)
4) [Pr.A] pre-current (pilot arc) = 20A (by default)
a) 8 ... 50А (change step 1А) for ProMIG-160
b) 10 ... 50А (change step 1А) for ProMIG-200
c) 12 ... 50А (change step 1А) for ProMIG-250
d) 12 ... 50A (change step 1A) for ProMIG-270
e) 14 ... 50А (change step 1А) for ProMIG-350
f) 16 ... 50А (change step 1А) for ProMIG-500
g) 18 ... 50А (change step 1А) for ProMIG-630
5) [Po.A] crater filling current = 20A (by default)
a) 8 ... 50А (change step 1А) for ProMIG-160
b) 10 ... 50А (change step 1А) for ProMIG-200
c) 12 ... 50А (change step 1А) for ProMIG-250
d) 12 ... 50A (change step 1A) for ProMIG-270
e) 14 ... 50А (change step 1А) for ProMIG-350
f) 16 ... 50А (change step 1А) for ProMIG-500
g) 18 ... 50А (change step 1А) for ProMIG-630
6) [t.uP] current build-up time = OFF (by default)
a) 0 [OFF] ... 15.0 sec (change step 0.1 sec)
7) [t.dn] current ramp-down time = OFF (by default)
a) 0 [OFF] ... 15.0 sec (change step 0.1 sec)
8) [Po.P] current pulsation power = OFF (by default)
a) 0[OFF] ... 80% (change step 5%)
9) [Fr.P] current pulsation frequency = 10.0 Hz (by default)
a) 0.2 ... 500 Hz (dynamic change step 0.1 Hz ... 1 Hz)
10) [dut] pulse/pause ratio (duty cycle) - it is the percentage of the larger current pulse to
the period of repetition = 50% (by default)
a) 20 ... 80% (change step 5%)
MIG/MAG welding mode
Left indicator of the source:
0) [-3-] main displayed parameter VOLTAGE = 19.0 V (by default)
a) 12 ... 24.0V (change step 0.1V ) for ProMIG-160
b) 12 ... 26.0V (change step 0.1V ) for ProMIG-200
c) 12 ... 28.0V (change step 0.1V ) for ProMIG-250
d) 12 ... 29.0V (change step 0.1V) for ProMIG-270
e) 12 ... 30.0V (change step 0.1V ) for ProMIG-350
f) 12 ... 40.0V (change step 0.1V ) for ProMIG-500