Warranty

2
Care & Cleaning
Troubleshooting
Warranty
□ Before attempting to clean the xture, disconnect the power to the xture by turning the breaker off or removing the fuse from the fuse box.
□ To clean the xture, use a dry or slightly dampened clean cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives, as damage to the xture may occur.
The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only
to the original consumer and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your
exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse,
abuse, accident, modications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set
up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty workmanship. This warranty shall not apply to the nish
on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specically
disclaims any warranty, whether expressed or implied, or tness for a particular purpose, other than the warranty contained herein. The manufacturer specically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the replacement or
repair of said product.
Contact the Customer Service Team at 1-800-283-6870 or visit www.GPWarranty.com.
Problem Possible Cause Solution
Lights do not turn on. □ No power
□ Disconnected/break in the
wire
□ Transformer setting
□ Check the outlet and ensure that a breaker or GFI circuit has not been tripped.
□ Follow the wires from the xture and ensure a continuous connected path back to the
transformer.
□ Check the settings on the transformer.
Lights icker. □ Loose wire connector to
the xture
□ Tighten the wire connector and ensure the metal contacts pierce the insulation on the low
voltage cable from the transformer.
Lights icker (all xtures). □ Loose connection at the
transformer
□ Unplug the transformer from the outlet and visually inspect the positive and negative con-
necting posts. Each wire should be securely screwed in and not in contact with any other.