Installation Guide

1
GPWarranty.com
Please contact 1-800-283-6870 for further assistance.
PACKAGE CONTENTS
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
Attaching and installing the
light
Connecting the wires
□ Attach the light (A) to the post (B) by inserting
the bottom of the light (A) into the top of the
post (B) and twisting it clockwise.
□ Attach the post (B) to the stake (C) by
inserting the bottom of the post (B) into the
top of the stake (C) and twisting clockwise.
□ Push the stake assembly into the ground by
grasping the post. Do not push on the light.
□ Mount the wire connector (D) to the lead wire from a
transformer (not included) by twisting the top of the wire
connector (D) off in a counterclockwise direction and
connecting the two wires.
□ Twist the top of the wire connector (D) back on in a
clockwise direction.
□ Repeat this step for each light assembly.
1 2
IMPORTANT: Protect the wiring by routing it in
close proximity to the light, tting, or next to a
building structure such as a house or a deck.
IMPORTANT: Do not bury the wiring by more
than 6 in. (152mm) in order to connect to the
main secondary wire.
IMPORTANT: Do not submerge in water. This
product could be damaged.
IMPORTANT: Do not install the light within 10 ft.
(3 m) of a pool, spa, or fountain.
A
B
C
D
D
CAUTION: The wire from the low voltage power
unit shall be 14-18AWG type underground Low
Energy Circuit Cable.
Assembly and Installation
Low Voltage LED Path Light
Use and Care Guide
Item #1000 021 213
Model #29633
C
B
D
A
Part Description Quantity
A Light 1
B Post 1
C Stake 1
D Connector 1