User Guide

FX200 User Guide
Version: 1.0 11
http://www.esmartlock.com
② Put the Maintenance card to the reader, and download the master card chip numbers
to the Card.
③ Put the Maintenance card to the locks, then, new Master cards will be registered to
the lock, and lost master card will be blocked.
(2) Using Owner Card
① Delete the old master card registrations in the lock (refer to the 4.1) with Owner Card.
② Put new master cards to each lock so as to register new master cards. Then, old
master card you lost will not be used.
☞ All existing Master cards needs to be registered again together with new Master card because
all master card registrations were deleted if Owner card is used.
4.3 User Card
4.3.1 Free Selection (Shared Use)
The initial status of the lock in Free Selection mode is open (Latch is inside).
(1) Initial Use
① Select the empty locker.
② Put your belongings in the locker.
③ Touch to wake up the lock, and place your card (or any form of user key) to the front body of
the lock.
④ Wait until the Green LED lights and Beep sounds once.
⑤ Latch will move out, and lock is closed.
⑥ Close the door. The lock will be remained at locking state.
(2) Open the lock
① Touch to wake up the lock.
② Put your user card to the front body of the lock.
③ Lock will check the lock ID and key of the user card (or any form of user key).
④ Lock will emit Green LED and beep sound once it is right user card.
⑤ Latch will be moved and locker will open.
⑥ User information will be erased from the lock so that new user can use the empty lock.
☞ In free selection mode, lock and card need to read and write the each other’s information. So