SWITCH TYPE Ceiling Fan Installation Manual
CONTENTS INSTALLATION & OPERATING INSTRUCTIONS FOR THE AEROFANTURE OWNER’S INSTALLATION, MANUAL SAFETY TIP P 01 UNPACKING YOUR FAN CONTAINS P 03 INSTALLING YOUR FAN STEP 01 - 04 P 04 STEP 05 - 08 P 05 STEP 09 - 10 P 06 STEP 11 P 07 STEP 12 - 13 P 08 A
OPERATING YOUR REMOTE CONTROL STEP 01 - 06 P 09 AFTER INSTALLATION “WOBBLE” P 10 NOISE P 11 CARE AND CLEANING P 11 SWITCH B
INSTALLATION & OPERATING INSTRUCTIONS FOR THE AEROFANTURE OWNER’S INSTALLATION, MANUAL * WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER THANK YOU FOR YOUR PURCHASE Thank you for purchasing this quality product. To ensure correct function and safety, please read and save all instructions before using the product.
9 After making electrical connections, spliced conductors should be turned upward and pushed carefully up into outlet box. The wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box. 10 WARNING: To reduce the risk of electrical shock and fire, do not use this fan with any solid-state fan speed control device, or rheostat. 11 Do not separate the reverse switch until the fan has come to a complete stop.
UNPACKING YOUR FAN TOOLS REQUIRED Phillips screwdriver Blade screwdriver 11 mm wrench Step ladder Wire cutters CONTAINS: Hanger bracket / Downrod / Canopy / Canopy Cover / Upper Blade Holder Ring System / Fan Motor Assembly / Blades x 3 / Receiver + Remote control incl.
INSTALLING YOUR FAN Fig.1a Turn Off Power Source or REMEMBER to turn off the power. Follow the steps below to hang your fan properly: STEP. 01 Pass the 120-volt supply wires through the center hole in the ceiling hanger bracket as shown in Fig. 1b. Secure the hanger bracket to the ceiling outlet box with the screws and washers provided with your outlet box. Fig.1b Fig.2 STEP. Blade screw A 02 Attach the blades to fan motor assembly using screws, spring washers and washers as shown in Figure 2.
INSTALLING YOUR FAN Fig.5 STEP. Loosen the 2 screws on the adapter at the top of the motor assembly. 05 Fig.6 Route the wires out of the top of the fan motor through the adapter, canopy cover and canopy and then through the downrod. STEP. Align the holes on the downrod with the adapter and carefully insert the hanger bolt through the hole. Be careful not to jam the hanger bolt against the wiring inside the downrod.
INSTALLING YOUR FAN Fig.9 Black White Grounded/Green Grounded/Green RED GREY YELLOW STEP. 09 OK NO Release 1 screw of the hanger bracket socket. Place the downrod ball into the hanger bracket socket. Make sure the hanger ball is seated in the groove on the hanger bracket. Rotate fan until notch on downrod ball engages the ridge on the mounting bracket.
INSTALLING YOUR FAN Fig.11 STEP. 11 Attach the canopy up to mounting bracket and align the screw hole with the canopy. Secure it by tightening the two set screws. Slide the canopy cover up to the canopy, turn canopy cover until it locks at the end of the circular holes.(Fig. 11) NOTE: Adjust the canopy screws as necessary until the canopy and canopy cover are snug.
INSTALLING YOUR FAN Fig.12 Assemble the decoration cover. STEP. 12 Fig.13 Align three circular holes on the link. Securely tighten them by twisting in a counterclockwise direction. STEP. 13 Align the 3 screws on the decoration cover with the large hole of the circular hole on the mounting bracket. Turn and tuck the decoration cover neatly into the mounting bracket until the 3 screws lock at the end of the circular holes.
OPERATING YOUR REMOTE CONTROL Installing the Remote Control : FOLLOW STEP 01-06 STEP. STEP. 01 03 STEP. 04 STEP. 05 STEP. 02 STEP.
Restore power to ceiling fan and test for proper operation.
3 Use the enclosed Blade Balancing Kit if the blade wobble is still noticeable. 4 If the blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight and possibly result in smoother operation. WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE BLADE ARM WHILE INSTALLING, BALANCING THE BLADES, OR CLEANING THE FAN. DO NOT INSERT FOREIGN OBJECTS BETWEEN ROTATING FAN BLADES.
12
SWITCH Ceiling Fan Installation Manual
