PEC 200 Manual_UK_Umschlag.indd 6 30.06.
Operation and Safety Notes ................................................... Page Manual_UK_Umschlag.indd 7 5 30.06.
햲 햳 햶 햵 햴 A B C D E F Manual_UK_Umschlag.indd 8 30.06.
Manual_UK_Umschlag.indd 9 30.06.
Kompernaß GmbH Burgstraße 21 · D-44867 Bochum (Germany) Last information update 01/2005 · Ident.-No.: PEC200-01/2005-UK Manual_UK_Umschlag.indd 10 30.06.
Manual_UK_Umschlag.indd 5 30.06.
Content Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. The following icons/symbols are used in this instruction manual: Read instruction manual! V~ Voltage Observe caution and safety notes! Wear protective gloves Ꮨ n0 Beware of electrical shock! Wear safety goggles Rated idle running speed Wear ear protection W Watt (performance) Introduction Your safety ..................................................................
Introduction/Safety Electric scraper/carver PEC 200 쐽 Introduction 쐽 Your safety Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle electrical power tools correctly. Further details can be found in the operating instructions . In addition to the above, you must also strictly observe the general safety advice contained in the accompanying booklet.
Safety/Before Use/First use · · · or the relevant service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. Always work with the mains lead leading away from the rear of the device. To avoid danger of injury and hazards to health: · Wear protective glasses.
First Use 쐽 Switching on the device Press the ON/OFF switch W into setting “0”. contact with the material to be worked. This allows you to position the tool exactly. 쐍 Begin at the flattest possible angle and lightest pressure. 쐍 Note that if you press on to backgrounds like tiles, wood or plaster too hard you could damage them. 쐍 The device and the tool attachment heat up if used for long periods. Do not overload the device and let it cool between sessions.
Cleaning and Disposal/Information 쐽 Cleaning and disposal 쐽 쐽 We, Kompernaß GmbH, Burgstr. 21, D-44867 Bochum, Germany, declare that this product complies with the following EU directives: Cleaning Pull the mains lead out of the mains socket before you clean the device. 쐍 Always keep the device clean, dry and free of oil or grease. 쐍 Clean the tool holder regularly. 쐍 Clean the tool attachment so that it is free of residues of adhesive or other contaminants.
