User's Manual

M7X and M7R Page 3-38 Operation
Back to Menu
(5) The next parameter is to attach a previously stored Waveform profile to the frequency preset.
Press Key 3 – Change (Fig 3-41). Pressing Key 9 to scroll up, or Key 10 to scroll down, highlight
the required waveform profile (Fig 3-43), then press Key 13 – Select.
Fig 3-43 Select Waveform Profile
(6) From the Frequency Preset Edit screen, press Key 4 – Change to select the required Frequency
(Fig 3-44). Using the keypad, enter the required frequency. [Note that any offset frequency is a
parameter of the waveform profile; the operating frequency should not include any offset.] If a
Maritime waveform profile is selected, a channel selection is required as shown in Fig 3-45.
Fig 3-44 Select Frequency
(7) When the correct frequency (or channel) is shown, press Key 13 – Select. The frequency preset
is now set up. Repeat this procedure for other frequency presets.