Replacement Instructions

5
Replacement
The following explanation uses the 42/50-inch plasma display as an example. The terminal board shown is a typical
example of one that can be replaced.
• Before proceeding with the replacement steps, be sure to turn off the entire system including the display, unplug
all components from their outlets, and disconnect all the interconnect cables from the display.
1. Removing the dummy cover or
mounted terminal board from
display:
• Remove the slot cover securing screws
(4 or 8 screws) on the back of the display.
If a terminal board is already installed,
grip the handle of the terminal board,
and slowly pull out in the direction of
the arrow.
2. Installing desired Terminal
Board:
1. Insert the desired Terminal Board into
the slot until it is firmly plugged into
the card connector.
• Make sure that the Board does not
ride on the two lower claws.
2. Secure using the previously removed
screws or those supplied with the unit.
Tighten screws in the numbered order
1 - 4 .
Please note that there are slot
fastening screws at 4 points on each
slot (at 2 locations on both the left and
right edges), so the number of
fastening screws will vary depending
on the number of slot insertions. Be
sure to fasten all screws tightly.
SLOT1
SLOT
2
SLOT
3
PC IN
S
L
O
T
1
S
L
O
T
2
S
L
O
T
3
P
C
I
N
SLOT1
SLOT
2
SLOT
3
S
L
O
T
2
S
L
O
T
3
P
C
A
U
D
IO
IN
R
L
P
R
/C
R
/R
P
B
/
C
B
/B
A
U
D
IO
V
D
H
D
Y/G
S
VID
E
O
IN
VID
E
O
I
N
V
ID
E
O
O
UT
R
L
CO
M
P
ONE
NT
/
RGB IN
A
V
S
L
O
T
2
S
L
O
T
3
A
U
D
I
O
SLOT
1
2
3
RGB(daigital)IN
The following example shows installation of a dual slot size board and a single slot size board.
S
L
O
T
1
S
L
O
T
2
S
L
O
T
3
P
C
IN
When Terminal Board is installed.
Foam mat or thick
soft cloth
3. Applying the terminal function
label:
Peel off the backing sheet from the
terminal function label (accessory) and
affix it over the existing label.
• Make sure that the label is affixed
with the correct position.
English
Have the customer keep the removed Terminal Board for future servicing needs.
Slot
Slot
Terminal function label
( accessory )
Terminal function label
( accessory )