Operating instructions

ManualsBrandsPanasonic ManualsTVs & monitorsTY-EW3D10

Operating Instructions

3D Eyewear

TY-EW3D10E

Model No.

Thank you for purchasing a Panasonic product.

Before using this product, be sure to read “Safety Precautions” and “Using Precautions”

( pages 2 - 5).

Before operating this product, please read the instructions carefully, and save this

manual for future use.

TQZJ232

This 3D Eyewear can be used

only for Panasonic Plasma HDTVs

supporting 3D.

For the latest information on

applicable models, visit our web site.

http://panasonic.net/

This product cannot and must not be

used as sunglasses.

This product can be worn over vision

correction glasses.

Contents

Safety Precautions ······························ 2

Using Precautions ······························· 5

Identifying Controls ····························· 6

Using for the  rst time ························· 7

Accessories ········································· 7

Using the 3D Eyewear ························ 8

Storage and Cleaning ························· 9

Replacing the batteries ······················· 9

Troubleshooting/Q&A ························ 10

Speci cations ···································· 11

ENGLISH

Summary of content (12 pages)

PAGE 1
Operating Instructions 3D Eyewear Model No. TY-EW3D10E Contents This product cannot and must not be used as sunglasses. This 3D Eyewear can be used only for Panasonic Plasma HDTVs supporting 3D. For the latest information on applicable models, visit our web site. http://panasonic.
PAGE 2
Safety Precautions Warning Small Parts This product contains small parts (battery and specialised band and nose pad, etc.) and must be kept out of reach of small children to avoid accidental ingestion. Disassembly Do not disassemble or modify the 3D Eyewear. About Lithium Battery Batteries must not be exposed to excessive heat such as sunshine, fire or the like. Caution About 3D Eyewear Do not drop, exert pressure on, or step on the 3D Eyewear.
PAGE 3
Viewing 3D Content Do not use the 3D Eyewear if you have a history of over-sensitivity to light, heart problems, or have any other existing medical conditions. Stop using the 3D Eyewear immediately if you feel tired, discomfort, or any other uncomfortable sensation. Take an appropriate break after viewing a 3D movie. Take a break of between 30 - 60 minutes after viewing 3D content on interactive devices such as 3D games or computers.
PAGE 4
3D Eyewear Use 3D Eyewear should not be used by children younger than 5 - 6 years old, as a guideline. All children must be fully supervised by parents or guardians who must ensure their safety and health throughout the using 3D Eyewear. Before using the 3D Eyewear, ensure no breakable objects surrounding the user to avoid any accidental damage or injury. Remove the 3D Eyewear before moving around to avoid falling or accidental injury.
PAGE 5
Using Precautions Do not drop or bend the 3D Eyewear. Do not apply pressure to or scratch the surface of the liquid crystal shutter of the 3D Eyewear. Do not soil the infra-red receiver section or attach stickers etc. to it. Do not use devices (such as mobile phones or personal transceivers) that emit strong electromagnetic waves near the 3D Eyewear as this may cause the 3D Eyewear to malfunction. Do not use 3D Eyewear outside the specified usage temperature range ( page 11).
PAGE 6
Identifying Controls Battery case Fitting the battery ( page 9) When using for the first time, remove the insulating sheet. ( page 7) Infra-red receiver Receives infra-red signals from the television. The liquid crystal shutter open/close timing is controlled by receiving infra-red signals from the television, which provide 3D expression of the images. If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes.
PAGE 7
Using for the first time Remove the insulating sheet Attach the specialised band If the 3D Eyewear slips out of place, use the specialised band included to hold it in place. Specialised band Attach the band to the left and right tips of the frame, and adjust the length. Insulating sheet Attach the nose pad If required, use the included nose pad. Nose pad A adjusts the attachment position of the 3D Eyewear between 2 vertical levels.
PAGE 8
Using the 3D Eyewear Using the television menu controls, set so that 3D images are shown. 1. (When 3D image signals are being received) press the MENU button on the television remote control. 2. Select “Setup”, and press the OK button. 3. Select “3D settings”, and press the OK button. 4. Select “3D Picture Display”, and use to select “3D” or “2D”. The procedure above is only an example. For details, see the television operating instructions. Wearing the 3D Eyewear 1.
PAGE 9
Storage and Cleaning Clean using a soft, dry cloth. Wiping the 3D Eyewear with a soft cloth that is covered in dust or dirt may scratch the eyewear. Shake off any dust from the cloth before use. Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off. Do not dunk the 3D Eyewear in liquid such as water when cleaning. Avoid storing the 3D Eyewear in hot or highly humid locations.
PAGE 10
Troubleshooting/Q&A Images are not 3D. Are the image settings switched to 3D images? Some 3D image signals are not automatically recognised as 3D images. Set “3D Picture Display” to “3D”. For details, see the television operating instructions. Is there a sticker or other such item blocking the infra-red reception section on the 3D Eyewear? If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes.
PAGE 11
Specifications Lens type Liquid Crystal Shutter Batteries (duration) Coin-shaped lithium battery CR2032 (approx. 75 hours in continuous use) Dimensions Width: Height: Overall length: Power supply DC 3 V Materials Main body: Resin Lens section: Liquid crystal glass Mass (including batteries) Approx.
PAGE 12
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. Please dispose of this item only in designated national waste electronic collection schemes, and not in the ordinary dust bin.