Operation Manual

You can attach all of the speakers (except subwoofer) to a wall.
 The wall or pillar on which the speakers are to be attached
should be capable of supporting more than 15 kg (33 lbs) for the
front speaker and more than 10 kg (22 lbs) for the surround or
the center speaker. Consult a qualifi ed building contractor when
attaching the speakers to a wall. Improper attachment may result
in damage to the wall and speakers.
 When mounting the front speakers to a wall, we recommend
using a string (not included) to prevent it from falling ( page 3).
Drive a screw (not included) into the wall.

Fit the speaker securely onto the screw(s)
with the hole(s).

(Except front speakers)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
 The stands must be able to support over 10 kg (22 lbs).

The stands must be stable even if the speakers are in a high
position.
Move the
speaker so
that the screw
is in this
position.
7.0 to 9.4 mm
(
9
/32 to
3
/8)
5.0 to 7.0 mm
(
3
/16to
9
/32)
Wall or pillar
4.0 mm (
5
/32)
255 mm
(10
1
/16)
320 mm
(12
19
/32)
190 mm
(7
15
/32)

RQT8656-P
F0206TS0
Plate thickness plus
7 mm to 10 mm
(plus
9
/32 to
13
/32)
5 mm (
3
/16), pitch 0.8 mm (
1
/32)
60 mm (2
3
/8)
Attach the stands
to these metal
screw holes.
Speaker stand
(not included)
In this position,
the speaker
will likely fall if
moved to the
left or right.
e.g. Center speaker
Panasonic Consumer Electronics Company,
Division of Panasonic Corporation of North America
One Panasonic Way Secaucus, New Jersey 07094
http://www.panasonic.com
 2006 Matsushita Electric Industrial Co., Ltd.
Printed in Malaysia
Panasonic Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
1 Pull down the longer part
of the cable, and then pull
the speaker cable out from the stand.
Preparation for front speakers
2 Feed the speaker cable into
the bottom of the speaker and
through the slot at the rear.
3 Connect the speaker cable.
(
 page 3)
Reattaching the cable to the stand
1 Remove the two screws from
the stand, and remove the
metal cover.
2 Pull the cable out about 40
cm
(15
3
/4) from the hole in
the metal cover, and insert
to the plastic cover.
3 Insert the metal cover so it
does not disturb the cable
and close tightly with the
two screws.
Note
Screws
Metal cover
Approx. 40 cm
(15
3
/4)
e.g.
Speaker installation options
Plastic cover
Plastic cover
Fitting speaker stands (not included)
Attaching to a wall
Other settings and optional speaker installation
RQT8656-P.indd 16RQT8656-P.indd 16 2006/02/28 16:52:152006/02/28 16:52:15