Instruction Manual

3
3
ENGLISH
VQT4X49
Supplied accessories
Check and identify the supplied accessories.
Maintenance
To clean this system, wipe with a soft, dry cloth.
Never use alcohol, paint thinner or benzine to clean
this system.
Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor,
away from obstacles, at a maximum range of 7 m
directly in front of the main unit.
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
1 Connect the FM indoor antenna.
Place the antenna where reception is best.
Use an FM outdoor antenna if radio reception is poor.
2 Connect the speakers.
Be careful not to cross (short-circuit) or reverse the polarity
of the speaker wires as doing so may damage the speakers.
3 Connect the AC mains lead.
Do not use an AC mains lead with other equipment.
Conserving power
The system consumes approximately 0.4 W when it is in standby
mode. Disconnect the power supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
You can connect a VCR, DVD player etc.
Note:
Disconnect the AC mains lead before connection.
Switch off all equipment and read the appropriate operating
instructions.
Components and cables are sold separately.
If you want to connect equipment other than those
described, refer to the audio dealer.
Sound distortion can occur when you use an adaptor.
1 x AC mains lead 1 x Remote control
(N2QAYB000896)
1 x FM indoor antenna 1 x Remote control
battery
2 x Speaker cables
R6/LR6, AA
33
111
22
RL
To household mains socket
Tape
(not supplied)
Black
Red
Black
Red
Copper
Silver
Connecting other equipment
DVD player (not supplied)
Rear panel of
this main unit
Audio cable (not supplied)
SC-PMX7EG-VQT4X49.book 3 ページ 2013年1月25日 金曜日 午前10時31分