Operating Instructions

12
SQT0935
3 Aim the TV’s remote control at this
system’s remote control sensor and
operate the TV.
≥ Connect only after all other connections
are completed.
A To a household mains socket
B AC mains lead for the main unit (supplied)
C AC mains lead for the active subwoofer
(supplied)
§ Insert the AC mains lead fully into the main
unit.
≥ This system consumes a small amount of AC
power (> 42) even when it is turned off. In the
interest of power conservation, if you will not
be using this system for a long time, unplug it
from the household mains socket.

≥ For the location of the TV’s remote control signal sensor,
refer to the operating instructions for the TV.
≥ Select a location that suits the environment.
≥ Make sure to clean the surface, where the adhesive tape
is to be attached.
≥ If you peel off the adhesive tape, the surface may
become damaged and exposed adhesive may remain.
Once you have confirmed the TV is operating correctly,
secure it by attaching the adhesive tape.
≥ When the TV receives signals from both its remote
control and the IR Blaster, their signals may interfere with
each other, making it impossible for you to operate the
TV.
Try using the TV’s remote control from a different angle.
AC mains lead connection
Saving energy
The main unit is designed to conserve its
power consumption and save energy.
≥ The main unit will automatically switch to
standby mode when no signal is input and
no operation is performed for approx. 20
minutes. Refer to page 30, “AUTO
POWER DOWN” to turn this function off.


※

SC-ALL70T-SQT0935.book 12 ページ ２０１６年１２月２１日 水曜日 午後２時４９分