Owner's Manual

- 10 -
Example-clutch
setting #40
Example-clutch
setting #20
3. Close the shutter with the clutch setting
handle by turning counterclockwise.
NOTE:
• Be sure to close the shutter to prevent
dust.
Tightening torque chart (reference
values)
This data consists of reference values measured
under the conditions described below. During
actual work, values will vary based on operating
conditions (lock bolt, target substrate, method
of securing the bolt in place, etc.).
Measurement conditions
As dened by Panasonic
0
2
4
6
8
10
12
(53.1)
(106.2)
(in·lbs)
1 10 3020 40 50 60
N
m
EYFGA3
EYFGA2
EYFGA1
Torque setting level
CAUTION:
• Always check the tool’s tightening
torque before use. Improper tool opera-
tion may result in excessive or inad-
equate tightening.
• Always operate the tool with the switch
fully depressed.
•
The torque accuracy may not be stable if
the switch is not sufficiently depressed.
• Use figures from the tightening torque
chart to guide your selection of torque
clutch setting. (See the tightening torque
chart)
Configuring Tool Settings
RPM adjustment setting
1. Turn off the control panel.
• If the control panel is on, remove and
then reinsert the battery pack.
2. Depress the switch while pushing the
button and then release both the but-
ton and the switch.
• After the LED light and tightening con
-
firmation lamp have illuminated and the
buzzer has rung, the control panel will
flash and change to configuration mode.
NOTE:
• Tools ship from the factory set to the
following mode.
EYFGA1: 80
EYFGA2: 75
EYFGA3: 45
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.