Operating Instructions
Table Of Contents
- Contents
- Before Use
- Preparation
- Basic
- Recording
- About the LCD Monitor
- Using the Zoom
- Taking Pictures Using the Built-in Flash
- Taking Close-up Pictures ([AF Macro]/[Macro Zoom])
- Taking Pictures with the Self-timer
- Compensating the Exposure
- Taking Pictures Using Auto Bracket
- Taking Pictures with different image effects (Creative Control Mode)
- Taking panorama pictures (Panorama Shot Mode)
- Taking pictures that match the scene being recorded (Scene Mode)
- Entering Text
- Using the [Rec] Menu
- Using the [Motion Picture] Menu
- Playback/Editing
- Wi-Fi
- Connecting to other equipment
- Others
- 206 -
Others
• Use within the communication range of the wireless LAN network.
• Connection types and security setting methods are different depending on the wireless access point.
> Refer to the operating instructions of the wireless access point.
• When the radio waves are interrupted, the condition may improve by moving the location or
changing the angle of the wireless access point.
• It may not automatically connect when the network SSID of the wireless access point is set not to
broadcast.
> Set the network SSID of the wireless access point to broadcast.
• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency operated
nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently away from
the device.
• Is the 5 GHz/2.4 GHz switchable wireless access point connected to other equipment using
the 5 GHz band?
> The use of a wireless access point that can use 5 GHz/2.4 GHz simultaneously is
recommended. It cannot be used simultaneously with this camera if it is not compatible.
• When the battery indicator is flashing red, the connection with other equipment may not start or the
connection may be disrupted. (A message such as [Communication error] is displayed.)
• Check if the wireless access point to connect is in operating state.
• The camera may not display or connect to a wireless access point depending on the radio wave
condition.
> Perform the connection closer to the wireless access point.
• It may not display even if the radio waves exist depending on the setting of the wireless access
point.
> Check the settings of the wireless access point.
• The wireless access point may not be found depending on the radio wave condition.
> Perform the [Manual Connection]. (P139)
• Is the network SSID of the wireless access point set not to broadcast?
> It may not be detected when it is set not to broadcast. Enter and set the network SSID. (P139)
• Try the following:
> Move this unit closer to the wireless access point
> Remove the obstacles between this unit and the wireless access point
> Change the direction of this unit
About the Wi-Fi function
It cannot connect to the wireless LAN. Radio waves get disconnected.
Wireless access point is not displayed. Or it cannot be connected.