Operating Instructions

- 37 -
Preparation
• This will work when the HDMI mini cable (optional) is connected.
• Refer to P176 for details.
• Use a battery with sufficient battery power or the AC adaptor (optional) when formatting. Do not
turn the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If the built-in memory or the card cannot be formatted, consult your nearest Service Center.
[VIERA Link]
Setup so this unit can be controlled by the remote control of the
VIERA by automatically coupling this unit with the VIERA Link
compatible equipment using HDMI mini cable (optional).
[OFF]: Operation is performed with the buttons on this unit.
[ON]: Remote control operation of the VIERA Link
compatible equipment is enabled. (Not all operations
are possible)
Button operation of the main unit will be limited.
} [SCENE MENU]
Set the screen that is displayed when the mode dial is set to ,
, , , and .
[OFF]: The recording screen in the currently selected
Advanced Scene Mode (P90) or Scene Mode (P95)
appears.
[AUTO]: The Advanced Scene Mode or Scene Mode menu
screen appears.
[MENU RESUME]
The last operated menu position is saved even if the camera is
turned off.
[OFF]/[ON]
[VERSION DISP.] It is possible to check which version of firmware is on the camera.
[FORMAT]
The built-in memory or card is formatted.
Formatting permanently deletes all data on your memory
card. Please be sure all pictures and motion pictures are
saved elsewhere before using this feature.
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or
send e-mail to: [e-mail]
For USA and Puerto Rico assistance, please call:
1-800-211-PANA(7262) or, contact us via the web at:
http://www.panasonic.com/contactinfo