Operating Instructions
4
A
U
T
O
HE
A
T
C
O
O
L
DR
Y
F
A
N
S
P
E
E
D
A
I
R
S
W
I
N
G
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
• Recommended temperature: 20°C ~ 24°C
HOW TO OPERATE
Notes:
• Use a screwdriver to short the two Reset Terminals on the
back of remote control to restore the remote control's default
setting.
• Remove the batteries if the unit is not to be used for a long
period.
REMOTE CONTROL TRANSMITTER
AUTO MODE - FOR YOUR CONVENIENCE
HEAT MODE - TO ENJOY WARM AIR
• Make sure it is not
obstructed.
• Certain uorescent lights
may interfere with signal
transmission. Please
consult your nearest
dealer.
Maximum distances : 8m
INDICATOR
INDICATOR
RECEIVER
RECEIVER
Close
Insert AAA or
R03 batteries
Pull out
Insertingthebatteries
• Unit selects the operation mode according to the room
temperature.
• Once auto mode is selected, the unit will operate at the
standard setting temperature.
• To change the standard setting temperature, press for
“
” or for “
”.
Room
temperature
Operation
mode
Standard
setting
temperature
(+2°C)
(–2°C)
23°C & above Cool 25°C 27°C 23°C
Below 23°C Dry 22°C 24°C 20°C
Below 20°C Heat 21°C 23°C 19°C
• Recommended temperature:
26°C ~ 28°C
COOL MODE - TO ENJOY COOL AIR
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
• Recommended temperature: 1°C ~ 2°C lower than room
temperature.
● Forheat,coolanddrymodes,therangeof
temperature can be selected from 16°C ~ 30°C.
DRY MODE - TO DEHUMIDIFY THE
ENVIRONMENT
Select Turn on Adjust
temperature
REMOTE CONTROL PREPARATION
REMOTE CONTROL PREPARATION
MODE OPERATION
MODE OPERATION
AUTO HEAT
DRY COOL
• The retention period of batteries might be affected
to be shorter because of the using times of the
remote control, even less than one year.
LCD display
F565573_en.indd 4 2006-11-30 13:35:43