CD Player/Receiver with Changer Control AUTO·P CQ-DFX301N REMOTE OPEN MONO/LOC VOL BAND PTY PWR TUNE SEL TRACK LOUD SOURCE CD RECEIVER WITH CHANGER CONTROL DISC EON EPTY ECT RANDOM SCAN CT DISP 1 2 3 R 4 5 SCAN REPEAT REP 6 REG AF SUB·W TA CQ-DFX301N Operating Instructions Bedienungsanleitung Manuel d’instructions Gebruiksaanwijzing Bruksanvisning Manuale di istruzioni Manual de Instrucciones ¡Please read these instructions carefully before using this product and save this ma
Label Indications and Their Locations Warnetiketten und deren Anbringungsort Indications portées les étiquettes et emplacement Aanduiding van de labels en hun plaats Varningsskyltarna, och deras placering Indicazioni delle etichette e le loro posizioni Indicaciones de las etiquetas y su ubicación VORSICHT! UNSICHTBARE LASERSTRAHLUNG! WENN ABDECKUNG GEÖFFNET IST, NICHT DEM LASERSTRAHL AUSSETZEN.
RDS (Radio Data System) .................................. 12 Clock Set ............................................................. 15 CD Player and CD changer ................................ 16 Installation........................................................... 18 Anti-Theft System ............................................... 21 Electrical Connections ....................................... 22 Speaker Connections ......................................... 24 Fuse .................................
Precautions (ISO Connector) ¡The pin arrangement of the power connector conforms to ISO standard. ¡The pin arrangement of ISO connectors in some cars may differ from the ISO standard. ¡Please check that the pin arrangement of the connector in your car conforms to ISO standard. ¡For car types A and B, change the wiring of the red and yellow leads as shown at right. ¡After connection, insulate the portions marked (C) with insulating tape.
ISO Standard ISO ¡IGN or ACC switched 12V supply ¡Zündschalter (ACC/IGN) ¡Sélecteur ACC/IGN ¡ACC/IGN schakelaar ¡tändningsomkopplare ¡Interruttore ACC/IGN ¡Llave ACC/IGN ¡+12 V Battery (Permanent supply) ¡+12 V-Batterie ¡Batterie +12 V ¡+12 V accu ¡+12 V batteri ¡Batteria +12 V ¡+12 V Batería A A7 (Red) (Rot) (Rouge) (Rood) (Röd) (Rosso) (Rojo) ACC BATTERY 15A A4 A4 (Yellow) C (Gelb) (Jaune) (Geel) (Gul) (Giallo) (Amarillo) (Yellow) (Gelb) (Jaune) (Geel) (Gul) (Giallo) (Amarillo) Car Type A ¡+12
E N G L I S H Panasonic welcomes you to their constantly growing family of electronic products owners. We endeavor to give you the advantages of precise electronic and mechanical engineering, manufactured with carefully selected components, and assembled by people who are proud of the reputation their work has built for our company.
Remote Control Unit (Option) E N G L I S H Battery Installation q Remove the battery holder. Take hold of the holder at position B and pull it out by pushing position A in the direction shown by the arrow. w Install the battery on the battery holder. Set a new battery properly with its (+) side facing up as shown in the figure. e Insert the battery holder. Push in the battery holder back into its original position.
E N G L I S H 3 Power and Audio Controls Power Turn the key in the ignition until the accessory indicator lights. Power on : Press [SOURCE] (PWR). Power off : Press [SOURCE] (PWR) again and hold. The panel removal alarm sounds. (a Page 21) Volume Anti-Volume-Blast Circuit When the power is switched off and on again, the volume slowly rises to the previous level. Remote control sensor for an optional remote control. [}VOL] : Up [{VOL] : Down Press and hold for rapid adjustment.
E N G L I S H Audio Mode (Bass/Treble/Balance/Fader) q Press [SEL] to select the audio mode. 4 Regular Mode Volume AUTO·P Fader Bass Balance Treble CQ-DFX301N REMOTE OPEN MONO/LOC VOL BAND PTY PWR TUNE SEL TRACK LOUD SOURCE CD RECEIVER WITH CHANGER CONTROL DISC EON EPTY ECT RANDOM SCAN CT DISP 1 2 3 R 4 5 SCAN REPEAT REP 6 REG TA AF SUB·W w Press [}VOL] or [{VOL] to change each level.
E N G L I S H 5 Radio Basics q Mode Selection (SOURCE) Radio Press [SOURCE] to select the radio mode. CD Player (When a CD is inserted) CD changer control (When a CD changer is connected) w Band Press [BAND] to change the bands. FM1 FM2 FM3 Band AM (LW/MW) FM stereo indicator AUTO·P CQ-DFX301N REMOTE OPEN MONO/LOC VOL BAND PTY PWR TUNE SEL TRACK ST LOUD CD RECEIVER WITH CHANGER CONTROL DISC EON EPTY ECT RANDOM SCAN CT DISP e Manual Tuning [[TUNE] : Higher frequency.
Preset Station Setting Caution: To ensure safety, never attempt to preset stations while you are driving. Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM (LW/MW) preset station memories. E N G L I S H 6 q Band Press [BAND] to select a desired band.
E N G L I S H 7 RDS (Radio Data System) RDS Basics The following functions are available when receiving RDS stations. PS Display CT Service AF (Program Service name) (Clock Time) (Alternative Frequency list) The name of station is displayed instead of the frequency. When receiving an RDS station, the CT (Clock Time) service automatically adjusts the time. "NO CT" is displayed in areas where CT service is not available.
RDS service availability varies with areas. Please understand if RDS service is not available in your area, the following service is not available, either. This chapter explains the summary and operation regarding RDS. Traffic Announcements Some RDS FM stations periodically provide traffic information.
E N G L I S H 9 RDS (Radio Data System) (continued) PTY Reception (Program Type) RDS FM stations provide a program type identification signal. Example: news, rock, classical music, etc. PTY Mode Press [PTY] to switch PTY display mode on or off.
Clock Set E N G L I S H When RDS CT service is not available, set the clock as follows. PTY Type Preset Program types are stored in memory under preset buttons [1] to [6] as shown in the table below. To tune in the desired program type, press any of preset buttons [1] to [6]. ype No. mT y a t r e g s pla Pre Pro Dis 1 News NEWS 1 NEWS 2 Speech 3 Sport 4 Pop.
E N G L I S H 11 CD Player and CD Changer Open Disc Insert and Playback q Open the front panel. w Insert a disc. e Close the front panel manually. Play back will start automatically. Caution: Make sure that the disc indicator ( ) is off before loading a disc. If the disc indicator is on, eject the disc. Listening to a CD Mode Selection OPEN MONO/LOC PTY Press [SOURCE] to select the CD or CD changer mode.
Note: The CD changer functions are designed for an optional CD changer unit.
E N G L I S H 13 Installation Preparation ¡Before installation, check the radio operation with antenna and speakers. ¡Disconnect the cable from the negative (–) battery terminal (see caution below). ¡Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. ¡We strongly recommend that you wear gloves for installation work to protect yourself from injuries. First complete the electrical connections, and then check them for correctness.
¡When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and fingers. 1 Insert Mounting Collar q into the dashboard, and bend the mounting tabs out with a screwdriver. Q’ty E N G L I S H 14 Supplied Hardware No.
E N G L I S H 15 Installation (continued) To Remove the Unit q Remove the removable face plate. Open Contact w Push q Open (a) Open the face plate. OPEN MONO/LOC PTY e Pull out PWR SOURCE (b) Push the face plate to either the right or left, then pull it out toward you. w Remove the trim plate t with a screwdriver. tTrim Plate Screwdriver 1 2 e Pull out the unit while pushing down the lock lever with a screwdriver. Lock Lever Screwdriver r Remove the unit pulling with both hands.
Anti-Theft System E N G L I S H This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable. r Removable Face Plate Case Place Removable Face Plate into Case 16 q Switch off the power of the unit. w Remove the removable face plate. (a Page 20) e Gently press the bottom of the case and open the cover. Place the face plate into the case and take it with you when you leave the car. Cautions: ¡This face plate is not water-proof.
E N G L I S H Electrical Connections Cable Wiring Diagram Example : Connection with CD changer CX-DP88N (Option) 17 CD Changer CX-DP88N Extension Cord (DIN/BATT/RCA/GND) (Black) (Yellow) Fuse (3A) Changer Control DIN Cord (L)(White) (R)(Red) RCA Cord CD Changer Control Connector Antenna CD Receiver CQ-DFX301N y ISO Antenna Adapter (If needed) L(White) R(Red) Preamp Out Connector (Rear) CD Changer Input Connector Rear Left + Rear Left – Front Left + Front Left – Front Right + Front Right – R
Ground Lead To a clean, bare metallic part of the car chassis Battery Lead To the car battery, continuous +12V DC Cautions: ¡Check the connectors provided on your car (see note on page 4 and 5) before connecting the system. ¡This unit is designed for use in a car having a 12-volt negative ground battery system. ¡To prevent damage to the unit, be sure to follow the connection diagram below. ¡Strip about 5 mm of the lead ends for connection (only nonISO connector cords).
E N G L I S H Speaker Connections Caution: Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers. 19 L + - R+ - (White) + - (White w/black stripe) (Gray) + - (Gray w/black stripe) ¡Use ungrounded speaker only. ¡The maximum speaker output should be 45 W or more. (If used with the optional power amplifier, the speaker output should be higher than the maximum amplifier output.) ¡The speaker impedance should be 4 - 8 Ω.
Specifications General FM Stereo Radio Power Supply Frequency Range Usable Sensitivity Stereo Separation : DC 12 V (11 V - 16 V), Test Voltage 14.4 V, Negative Ground Tone Controls : Bass; ±12 dB at 100 Hz Treble; ±12 dB at 10 kHz Current Consumption : Less than 2.5 A (CD mode, 0.
Matsushita Electric Industrial Co., Ltd. Central P.O. Box 288, Osaka 542-8588, Japan Matsushita Communication Deutschland GmbH Lahnstraße 5 Industriegebiet Süd 24539 Neumünster, F.R.