Operating instructions

ManualsBrandsPanasonic Manualscar media receiversCQDF602W

CQ-DF602W

General

CQ-DF602W

Before Reading these Instructions

You can operate this unit by pressing buttons on the main unit and the remote control unit.

∫ These instructions describe buttons that are concerned with operations as follows.

Example: Press [P·SET "] or [P·SET #]/["] or [#].

∫ Some operations can be activated by pressing buttons only on main unit or remote control unit.

Those cases are described in the instructions.

Example: Press [OPEN] on the main unit.

Battery Installation

1 Remove the battery holder.

Pull the battery holder by the position B while pushing

position A in the direction indicated by the arrow.

2 Install the battery on the battery holder.

Set a new battery properly with its “i” side facing up

as shown in the ﬁgure.

3 Insert the battery holder.

Push the battery holder back into its original position.

Battery Notes

Remove and dispose of an old battery immediately.

Battery Information:

≥ Battery type: Panasonic lithium battery (CR2025) (included)

≥ Battery life: Approximately 6 months with normal use (at room temperature)

≥ Do not disassemble or short the battery. Do not throw a battery into a ﬁre.

≥ Keep batteries away from children to avoid the risk of accidents.

≥ Be careful to observe proper local disposal rules when you dispose of batteries.

Caution:

≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a ﬁre.

Battery leakage may damage the unit.

[buttons on the main unit]/[remote control unit]

Point the remote control unit at the main unit’s sensor.

Remote Control Unit Preparation

Lithium battery

(included)

Back side

Position B

Position ABattery holder

Note:

≥ When the power is switched on for the

ﬁrst time, a demonstration message ap-

pears on the display.

To cancel this display, press [DISP] (dis-

play).

[SOURCE]

(POWER)

[DISP]

(Display)

Power

Turn the key in the ignition until the accessory in-

dicator lights.

ON: Press [SRC] (PWR)/[SOURCE] (POWER).

OFF:Press and hold [SRC] (PWR)/[SOURCE]

(POWER) again for more than 1 second.

≥ After turning off the ignition key, a security

message is displayed, and the panel removable

alarm that reminds you to take the panel is acti-

vated.

(When security function is set to on ➡ page 28)

Source

Press [SRC] (SOURCE)/[SOURCE] to change the source.

Radio

CD player

CD changer control

AUX-IN setting

(When a CD is in the player.)

(When a CD changer is con-

nected and magazine is in the

changer.) (➡ page 20)

SRC

DISP

SET

CQ-DF602W

;

/ 1

OPEN

BAND

TUNE

TRACK

CD RECEIVER WITH FULL DOT MATRIX DISPLAY

DISC

SET/APM

VOLUME

MOSFET

50W

Remote control signal sensor

Summary of content (10 pages)

PAGE 1
E N G L I S H Before Reading these Instructions General You can operate this unit by pressing buttons on the main unit and the remote control unit. 1 ∫ These instructions describe buttons that are concerned with operations as follows. Example: Press [P·SET "] or [P·SET #]/["] or [#]. 1 Power Turn the key in the ignition until the accessory in- E N G L I S H 2 dicator lights. ON: Press [SRC] (PWR)/[SOURCE] (POWER). OFF:Press and hold [SRC] (PWR)/[SOURCE] (POWER) again for more than 1 second.
PAGE 2
E N G L I S H General (Continued) 3 On the main unit: Turn [VOLUME] dial Clockwise: Up Counterclockwise: Down Volume E N G L I S H Display Change 4 M EN U When Power is ON PUSH Open/Close the Front Panel Down VO Mode display OPEN: Press [OPEN] on the front panel. CLOSE: Raise the panel by hand. Up LU Press [DISP] (display).
PAGE 3
Radio E N G L I S H Mode 1 Radio Press [SRC] (SOURCE)/[SOURCE] to change to 5 Caution: ≥ To ensure safety, never attempt to preset stations while you are driving. the radio mode. E N G L I S H One-Touch Selection of a Preset Station 6 Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories. 1 Select a band and frequency (steps 1, 2 and 3 on the previous page).
PAGE 4
CD Player E N G L I S H Disc Insert and Playback Caution: ≥ Only 12 cm CD, CD-DA data recorded CD-R and CD-RW discs are available for this unit. ≥ This unit does not support CD text display. ≥ This unit does not support MP3 disc playback. ≥ Refer to page 35 about notes on CD-Rs/RWs. ≥ To avoid damaging the front panel, do not push it down or place objects on it while it is open. ≥ Do not use irregular shaped discs. ≥ Do not use discs that have a seal or label attached.
PAGE 5
CD Player (Continued) E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Menu Setting on CD Player Mode 9 [P·SET "] [P·SET #] (Submenu) [BAND] (Setting) [MENU] [DISP] (Display) CQ-DF602W MUTE DISP MOSFET 50W X 4 E N G L I S H 10 OPEN P.
PAGE 6
CD Changer Control E N G L I S H E N G L I S H CD changer functions are designed for optional Panasonic CD changer unit. Preparation: ≥ Connect the CD changer, and load a magazine (disc). Note: ≥ Loading a magazine when the power is off allows the power to be turned on. ≥ Ejecting the magazine when the unit is in the CD changer mode allows the power to be turned off. ≥ This unit does not support CD-ROM, CD-R or CD-RW playback through the CD changer.
PAGE 7
CD Changer Control (Continued) E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Menu Setting on CD Changer Mode 13 [P·SET "] [P·SET #] (Submenu) [MENU] [DISP] (Display) [BAND] (Setting) CQ-DF602W MUTE DISP MOSFET 50W X 4 E N G L I S H 14 OPEN P.
PAGE 8
Audio Settings [AUDIO] E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Audio menu display [P·SET "] [P·SET #] (Submenu/setting) [MENU] [DISP] (Display) [BAND] (Setting) 15 CQ-DF602W MUTE DISP MOSFET OPEN 50W X 4 E N G L I S H 16 P.
PAGE 9
Picture (Display) Settings [PICTURE] E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Picture (display) menu display [P·SET "] [P·SET #] (Submenu/setting) [MENU] [DISP] (Display) [BAND] (Setting) 17 CQ-DF602W MUTE DISP MOSFET 50W X 4 E N G L I S H 18 OPEN P.
PAGE 10
Clock Basics E N G L I S H 1 Menu 19 2 Submenu M EN U 1 Press [MENU]/[SEL] (MENU). PUSH Clock Adjustment (24 hour system) Default: “ADJUST” (not adjusted.) VO LU ME (Press.) 2 Press [TUNE $] or [TUNE %]/[$] or [%] to select “PICTURE” tab. 1 Press [P·SET "] or [P·SET #]/["] or [#] to select ∫ CLOCK ADJ . 2 Press [BAND] (SET) to set. E N G L I S H 3 Setting Hours set. 20 1 [TUNE %]/[%]: The hour display highlights. 2 [P·SET "]/["]: Put forward. [P·SET #]/[#]: Put back.