Installation guide

SCREW- 1/4-20 X 3/4" HEX HEAD BOLT (4X)
1/4" SPLIT LOCK WASHER, (4X)
1/4" SAE FLAT WASHER, (4X)
( OPTIONAL )1/4" SAE FLAT WASHER, (4X)
USE ONLY WHEN MOUNTED TO A NON-HDM
POLE THAT ARE 1/8" THICK OR LESS MATERIAL
ISOVIEW FROM BOTTOM
LEVER TO LOCK AND
RELEASE ROTATION
HANDLE TO LOCK AND
RELEASE DEVICE'S SLIDE
MOTION DEVICE PLATFORM
FOR MD -200 SERIES (OPTIONAL)
HARDWARE KIT CONTENTS:
INSTALLATION INSTRUCTIONS:
1. PLACE MD-100 SERIES MOTION DEVICE ON TOP OF POLE
MOUNTING SURFACE.
2. LINE UP THE 4 TAPPED HOLES IN THE UPPER POLE
MOUNTING SLOTS.
3. ATTACHED THE 4 HEX BOLTS & LOCK WASHERS AND FLAT
WASHER AS SHOWN THROUGH THE THREADED HOLES OF
THE MOTION DEVICE.
4. TIGHTEN THE SCREWS TO 90 10% INCH-POUND TORQUE .
NOTES:
IF MD-200 MOTION DEVICE SERIES IS NOT INSTALLED, 1.
REFER TO MD-200 SERIES INSTALL INSTRUCTIONS.
IF THE UNIT IS NOT USED WITH HDM-200 POLE SERIES 2.
AND ATTACHED TO A SURFACE LESS THAN 1/8" THICK,
ADD THE OPTIONAL STEEL FLAT WASHER INCLUDED TO
A HARDWARE KIT (SEE VISUAL AID INSTALLATION
GUIDE).
HEAVY DUTY MOUNT - UPPER POLE
(HDM -200 SERIES -NOT INCLUDED)
D
C
B
A
A
B
C
D
1
2
3
4
4
3
2
1
PROPRIETARY AND CONFIDENTIAL
ALL DIMENSIONS ARE IN INCHES
ALL THREADS ARE IN UNC-2A/2B OR
UNF-2A/2B AFTER COATING AND
TOLERANCES ARE:
.XX .XXX ANGLES
.02 .010 .5 DEG
MATERIAL:
FINISH:
DRAWN BY: Paul Melaya
CHECKED BY: -
SIZE
B
SCALE: 1:4
UNLESS OTHERWISE SPECIFIED:
SHEET 1 OF 2
DO NOT SCALE DRAWING
75 JACKSONVILLE RD,
WARMINSTER, PA. 18974
1-800-524-9900
REF #
AREA(SQ. IN.): 600.56
THE INFORMATION CONTAINED IN THIS DRAWING
IS THE SOLE PROPERTY OF HAVIS, INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF HAVIS IS PROHIBITED.
WEIGHT (LB): 7.27
TITLE:
DWG. NO.
REV
SEE BOM
C-MD-104-INST
DESIGNED BY:
3/23/10
HAVIS, INC.
STANDARD
SPEC'S
REQUIRED:
98-000004
Paul Melaya
N/A
N/A
MD-100 SERIES
MOTION DEVICE