User's Manual Part 1
108
Sound/Screen/Light Settings
You can set the vibrator to notify you of incoming calls and mail.
1
mSet./ServiceIncoming callVibrator
Select an incoming typeSelect a vibration pattern.
Pattern 1. . . . . . . . . Alternates between vibration on (about 0.5 second) and off
(about 0.5 second).
Pattern 2. . . . . . . . . Alternates between vibration on (about 1 second) and off
(about 1 second).
Pattern 3. . . . . . . . . Alternates between vibration on (about 3 seconds) and off
(about 1 second).
Melody linkage . . . Vibrates in time with the vibration pattern stored in the melody.
OFF . . . . . . . . . . . . . Does not vibrate.
While you are selecting a pattern, the FOMA terminal vibrates by the selected
pattern for confirmation. However, it does not vibrate if you select “Melody
linkage”.
The following icons are displayed on the Stand-by display while “Vibrator” is set to
other than “OFF”:
: You set “Phone”, “PushTalk”, or “Videophone”.
: You set “Mail”, “Chat mail”, “MessageR”, “MessageF”, or “i-concier”.
: You set “Phone”, “PushTalk”, or “Videophone”, and set “Mail”, “Chat mail”,
“MessageR”, “MessageF”, or “i-concier”.
+m-5-4
<Vibrator>
Informing You of an Incoming Call by
Vibration
Information
The priority order of vibrators is as follows: “Setting for Phonebook entry” → “Group
setting” → “Vibrator”.
Even when “Melody linkage” is set, the FOMA terminal vibrates with “Pattern 2” if an
i-motion movie or melody with no vibration pattern is set for the ring tone.
Be careful not to leave the FOMA terminal on a desk or similar places with the vibrator
activated; when a call comes in, the FOMA terminal might move and fall by vibration.
You can set the sound recorded with the FOMA terminal for a ring tone
(including a ring tone for Number B of 2in1), On-hold tone/Holding tone,
alarm for “Alarm”, “Schedule”, “ToDo”, and “TV timer”, and answer
message for Record Message.
You can record only one item for about 15 seconds.
1
mLifeKitRec.msg/voice memoVoice announce
Record
To suspend recording midway, press Oo(), h, or r. The contents
recorded to that point are saved.
The tone beeps about 5 seconds before the recording time (for about 15
seconds) ends. When recording ends, the tone beeps twice, and the former
display returns.
The recording is suspended when a call comes in, when an alarm for “Alarm”,
“Schedule”, “ToDo”, “TV timer”, or “Timer recording” sounds, or when you switch
displays using Multitask during recording. (The contents recorded to that point are
saved.)
To play back the recorded sound, select “Play”. To suspend playback midway,
press Oo(), h, or r.
To erase the recorded sound, select “Erase”, then select “YES”.
Melody Call is a service that changes the ringback tone phone callers
hear, to a melody you like.
For details, refer to “Mobile Phone User’s Guide [Network Services]”.
Melody call is a pay service which is available on a subscription basis.
1
m
Set./Service
Incoming call
Melody Call setting
YES
Operate following the instructions on the display.
+m-5-5
<Voice Announce>
Using Recorded Sound as Ring Tone
<Melody Call Setting>
Changing Ringback Tone