operating manual & parts list General Purpose Angle VISES Models: 9611152 9611253 9611255 Read carefully and follow all safety rules and operating instructions before first use of this product. 9650001.
Palmgren Operating Manual & Parts List DESCRIPTION SAFETY RULES Palmgren General Purpose Angle Vises are assembled in the U.S., and are constructed from fine grain cast iron with replaceable steel jaw plates. Lead screws on all models are precision cut V-thread. Palmgren General Purpose Angle Vises permit accurate positioning at any angle from horizontal to vertical. Model 9611255 comes with a 360° swivel base with a 5/8" keyway. Center of base is open for holding work through body of vise.
Palmgren Operating Manual & Parts List Figure 2 - Replacement Parts Illustration for General Purpose Angle Vises REPLACEMENT PARTS LIST FOR General Purpose Angle VISES Ref. No. Description 1 2 3 4 5 6 7 8 9 Body Follower Lead Screw Assembly Bottom Plate Kit Jaw Plate Kit Swivel Base Kit Angle Base Kit Single Side Plate Kit Palmgren Nameplate Model 9611152 Model 9611253 Model 9611255 N/A N/A 9610008.00 9610024.00 9610014.00 9610101.10 9610050.00 N/A N/A N/A 9610010.00 9610025.00 9610015.00 9610201.
Palmgren Operating Manual & Parts List WARRANTY Palmgren warrants their products to be free of defects in material or workmanship. This warranty does not cover defects due directly or indirectly to misuse, abuse, normal wear and tear, failure to properly maintain the product, heated, ground or otherwise altered, or used for a purpose other than that for which it was intended. The warranty does not cover expendable and/or wear parts (i.e.