Tile Installation Guide PALISADE READ tis entire installation guide before beginning your installation. ACP is not responsible and will not be held label for project failures if installation guidelines are not followed. ACP recommends that you Install these ties over an existing substrate to ensure proper structural integrity. Palisade tiles are not intends to be attached to raw concrete, poured concrete walls or concrete block basement walls.
Qut panels for outlets and light switches. Measure and mark the borders whats the opening will be with a marker. Drill & hole using a drill in a corner of tha cut-out section {image FJ. Use & fig saw io out the remaining opening, following your tracing (mags G). Do not atishoo accessories lke coat hooks, light fittings, minors, ele. directly to the ties. Drill holes through the tiles and uss sultanate anchors to attach the accessories securely Into the framing behind. Seal par sealant Instructions.
Net, determine the length of the tis section. Measure from tha inside lip of the previous installed tis to the inside adj of the per-installed trim. Ses image at right for details. In this case, the length to cut the final tile the row is {image RY). Afar cutting tile to length, apply adhesive to the substrate, as shown {mags S). Insert the cut tis edge Intel the L-vim wheels haling the Interlocking Joln-adige away from lis mating tie.