Installation Guide

Barn Door

Soft Close Instructions

Taking Pride in Providing You the Perfect Door

TOOLS AND PARTS LIST

Soft Close Instructions.pdf page 1 of 1

rev. 7-30-17

BEFORE GETTING STARTED: PRECAUTIONS

TOOLS

PARTS

Power

Drill

5/32” Drill Bit

1/16” Drill Bit

Phillips Head Screwdriver

Soft Close Mechanism

Keepers

Left and Right Tracks with Installed Soft Close Mechanism

1. Please wear safety gear appropriate to tools being used. Eye protection should be used at all times. Failure to use protective

eye gear can result in serious injury. ALWAYS wear proper safety gear when operating power tools.

2. Always insure you have ample space to operate power tools with complete control of the power tool.

3. Note: The Soft Close Mechanisms come installed on the tracks.

INSTALLING THE KEEPER

1. Follow all instructions for installation of your Barn Door

2. Move doors to desired center, leaving a 1/32” gap.

3. Place the Soft Close Keeper on top of the RH door as shown

in figure and mark through the door keeper slots.

4. Remove door and drill 1/16” pilot holes where marked.

5. Mount Soft Close Keeper.

6. Repeat for LH door

7. Re-install doors.

RH track

soft close

(catch visible)

soft close keeper

track connector

header board - (not supplied)

Left and Right Tracks attached to header board with installed track connectors

PAGE 1
Barn Door Soft Close Instructions Taking Pride in Providing You the Perfect Door TOOLS AND PARTS LIST TOOLS 1/16” Drill Bit 5/32” Drill Bit Power Drill Phillips Head Screwdriver PARTS Keepers Soft Close Mechanism Left and Right Tracks with Installed Soft Close Mechanism header board - (not supplied) track connector Left and Right Tracks attached to header board with installed track connectors BEFORE GETTING STARTED: PRECAUTIONS 1. Please wear safety gear appropriate to tools being used.