INSTALLATION GUIDE Quincy Single Lever Arc Spout Bathroom Faucet W/ Pop Up PB-L01
RECOMMENDED TOOLS AND MATERIALS ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ Plumbers Putty Silicone Sealant Adjustable Wrench Tape Measure Basin Wrench Phillips Screwdriver Pencil Masking Tape BEFORE YOU BEGIN There are a variety of things to do before installing any new plumbing system into your home or residence.
INSTALLATION OF THE FAUCET Before starting turn off both the hot and cold water supply lines and remove the old faucet. Clean around all areas of attachment before placing new faucet on sink to help prevent corrosion after installation.
2 Secure Faucet Remove both the lock-nut and washer provided. Place faucet on sink by feeding hoses down through the center hole in the sink. From below secure faucet by re-attaching lock-nut and washer and screwing down until tight. Make sure you tighten lock the nut before the screws. 3 Install Drain Remove the stopper from the drain and unscrew drain from plastic pipe. Remove plastic locknut, washer, and rubber seal from the drain.
4 Install Horizontal Pivot Rod Remove the Retaining nut being sure to leave the plastic ring inside. Remove the Metal spring attached to the horizontal pivot rod, set aside. Insert the horizontal pivot rod, ball first, into the pipe. Feed the retaining nut over the rod and lightly attach without tightening.
Attach Clevis Put the spring from the horizontal pivot rod halfway onto the rod. While it is still half on attach the clevis (choosing the hole to match the needed height for your sink or preference). Lock the clevis into place by completely attaching the spring and sliding it along the horizontal pivot rod to a desired location. 7 Attach Stopper Rod Loosen the clevis screw until you can insert the stopper rod.
8 Connect Supplies With the stopper correctly installed (you should be able to push it up and down now) securely attach marked supply lines with corresponding hot and cold tubes from faucet. Tighten all connections with wrench to ensure that no leaking occurs. With all pipe attachments plumbers tape can be utilized to help reduce the risk of leaking. 9 Flush Lines Remove the aerator. Turn on the hot and cold water supply lines.
Limited Lifetime Warranty Pacific Bay products have been manufactured under the highest standards of quality and workmanship. Pacific Bay warrants to the original purchaser for as long as the original purchaser owns their home that this faucet will be leak- and drip-free during normal use and that all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.
