Software manual User Manual

Chapter 5
UNDERSTANDING THE
BUTTONS AND
MENUS
to send the database and parameters to the AeGIS 9000 Series.
to receive the database, event logs and parameters from the AeGIS 9000 Series.
Read all the function of each button and menu before you start any programming, sending or receiving the data from or to
the AeGIS 9000 Series.
Send
Receive
Pach and Company Chapter 5 Page 14
AeGIS 9000 Series Management Software BUTTONS AND MENU 03/01/02
BUTTONS FUNCTION
Figure 5.1
[Connect] Click this button to connect to the AeGIS 9000 Series via modem
or RS-232. The Received Content screen shows Connect 1200
NoEC or Connect 1200
[Master Code] Enter the AeGIS 9000 Series Master Code (default 0000) in the
master code text box and click the [Master Code], the Received
Content screen shows <Programming> Access Granted. If the
Received Content screen shows <Error> ..Illegal Command..,
click the [Master Code] again. The master code is invalid if the
screen does not show <Programming> Access Granted.
[Receive] Click this button to enable the buttons on Receive Frame (figure
5.4), then use the buttons to receive data from the AeGIS 9000
Series.
[Send] Click this button to enable the buttons on Send Frame (figure 5.3),
then use the buttons to send data to the AeGIS 9000 Series.
[Disconnect] Click this button to disconnect. Warning: Click [End] button after
sending the tenant database then click [Disconnect] after ..End
Programming.. shows on the Received Content.
[End] This button is only use after sending the Tenant Database. It is not
necessary to click [END] button after sending Access Code,
Auto Schedules, Holiday, and Time Zone Database.
[Help] Is not enabled.
Comm Mode Select Modem or RS-232
Select Port Select Port 1-4.
[Date] Send the current PC date to the AeGIS 9000 Series.
[Time] Send the PC current time to the AeGIS 900 Series.