User Manual

Vandal Resistant Reader - Installation
17063 Ver 1.6 DRAFT B 4 Easikey Readers
3. Vandal Resistant Reader - Installation
12
100
100
70
705
5
This reader should be mounted using the Vandal Resistant screws provided.
Note
A special screwdriver (not supplied) is required to use these screws.
3.1 Fixing the Reader
The cable from the controller should come to the rear of the reader. Leave enough cable
exposed to allow easy wiring of the reader (at least 20mm).
Note
The terminals protrude 5mm from the rear of the reader. You should ensure there is a
void large enough (about 40mm square and 20mm deep) behind the reader to
accommodate the terminals and excess suppression cable.
1. Ensure that the reader cable is not connected to the controller. Wire the reader to the cable
as described in the documentation supplied witrh the controller.
2. Apply a silicone sealant to the terminals to protect against moisture if the reader is mounted
outside.
3. Fix the reader to as flat and even a surface as possible. This will reduce the possibility of it
being levered from the wall. Either use the Vandal Resistant screws provided, or other
suitable fixings. The LED should be to the top.