Instructions / Assembly

• Angled Impaling Clips

(use two per panel)

• Anchor Screws

Parts Included with Panel:

Tools You May Need For Your Project:

Tape Measure

#2 Phillips

Screwdriver

Level

ACOUSTICAL PANEL

Sound Control with Style

Fabric

INSTALLATION INSTRUCTIONS:

1. MEASURE Determine the placement of the panel on the wall.

Use painters tape to mark the wall where hanging

clips (included) should go. Ensure hanging clips

(included) should go. Ensure hanging clip

placements are at least three inches away

from the edges of the panel.

HARDWARE

Use a level or laser tool to ensure that the hanging

clips are level so that the panel will engage all

hanging clips evenly. Once hardware is level,

attach hanging clips using the included screws

and a screwdriver.

3. MOUNTING Position panel 5/8 inch above placement position

so that it is lightly touching the points of the hanging

clips. With your hands placed on the panel face,

push the panel down toward the wall until it is seated

on the hanging clips.

4. LEVEL Position a wooden block on edge of panel and use

a hammer to lightly tap for adjustment. If panel must

be adjusted up, remove and re-seat panel on clips,

do not tap upwards. Inspect the edges on the panel

where it mee

ts the wall. The gap should be

consistent around the entire perimeter of the panel.

Pub. No. 10023377. Printed in U.S.A. January 2019.