Installation Guide

INSTRUCTIONS

Installation manual

IMPORTANT:Before starting to install the equipment,

Screw the hanger onto the roof as shown in the figure. Use different screws

1.INSTALL THE SUSPENSION BRACKET

according to the type of ceiling.

please check whether the main power socket is turned off.

Hanger

ball

Canopy

Downrod

Cover

R pin

Setscrew

Coupler

Corss pin

motor

housing

PAGE 1
INSTRUCTIONS Installation manual IMPORTANT:Before starting to install the equipment, please check whether the main power socket is turned off. 1.INSTALL THE SUSPENSION BRACKET Screw the hanger onto the roof as shown in the figure. Use different screws according to the type of ceiling.
PAGE 2
. WIRING TUTORIAL The controller is built-in and does not require disassembly and installation 2.Carefully lift the fan joint and place it on the shaft of the hanger.Make sure that the hole of the bracket and the structure to be connected are aligned with the upper flange of the hanger.After wiring, press upward and twist to adjust the position of the screw hole to connect the canopy to the suspension bracket. Later,Connection of fixing screws. 1.