Installation & Assembly

Please consult your electrician for hanging fixture and wiring.

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

MADE IN CHINA

Page 1 of (2)

Due to inrush current wattage should not

exceed 150 watts of product for a 600 watt

dimmer.

Warning: Wires need to be connected to driver

found in canopy and should not be connected

directly to power source or a short may occur.

The fixture is designed to dim with a standard

Triac forward phase dimmer. Dimming levels

will vary by dimmer.

Below is a list of recommended dimmers:

Lutron MACL-153M

Lutron DVL-153P

Lutron SCL-153P

Leviton IPL06-10Z

Leviton 6674-POW

PAGE 1
Please consult your electrician for hanging fixture and wiring. The fixture is designed to dim with a standard Triac forward phase dimmer. Dimming levels will vary by dimmer. Below is a list of recommended dimmers: Lutron MACL-153M Lutron DVL-153P Lutron SCL-153P Leviton IPL06-10Z Leviton 6674-POW Due to inrush current wattage should not exceed 150 watts of product for a 600 watt dimmer.
PAGE 2
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation (A) Mounting Bracket (F) Finial (C) Anchors Locate all hardware & components before discarding packaging 1.) (A) (C) (D) (B) (A) (C) (D) (B) (E) (F) Step.1: Remove mounting bracket from fixture and install to electrical box using screws (D). Mark where screws at ends of bracket (A) meet the ceiling. Remove mounting bracket (A) from ceiling. Drill holes using 3/16"± drill bit where marked.