User's Manual

16


1. Set Up for Right Front (RF) Tire Sensor
The RF tire symbol will be flashing green with a blue “1” on the display. This means the RF
tire is ready for the set up as per below, Fig. 1, in the meantime, the user should deflate the
tire pressure rapidly over 0.3bar/30kPa or 4 psi within 15 sec. until there is a beep sound,
which means the user has completed the set up for RF tire. The system will then proceed
to RR tire sensor set up mode as shown below Fig. 2. If there is no need to set up the RF
tire sensor, just press the SET button to skip this process.

Fig. 1 Fig. 2

2. Set Up for Right Rear (RR) Tire Sensor
The RR tire symbol will be flashing green with a blue “2” on the display. This means the RR
tire is ready for the set up as per below, Fig. 1, in the meantime, the user should deflate the
tire pressure rapidly over 0.3bar/30kPa or 4 psi within 15 sec. until there is a beep sound,
which means the user has completed the set up for RR tire. The system will then proceed to
LR tire sensor set up mode as shown below Fig. 2. If there is no need to set up the RR tire
sensor, just press the SET button to skip this process.

Fig. 1 Fig. 2

3. Set Up for Left Rear (LR) Tire Sensor
The LR tire symbol will be flashing green with a blue “3” on the display. This means the LR
tire is ready for the set up as per below, Fig. 1, in the meantime, the user should deflate the
tire pressure rapidly over 0.3bar/30kPa or 4 psi within 15 sec. until there is a beep sound,
which means the user has completed the set up for LR tire. The system will then proceed
to LF tire sensor set up mode as shown below Fig. 2. If there is no need to set up the LR
tire sensor, just press the SET button to skip this process.