Product Manual
520-120 / 530-120H
26
PLACING THE CHAIN IN THE VISE
β Clean the chain before sharpening it.
β Check the cutters and ξnd the one with the most damage, you will want to start with this cutter.
β Ensure chain is placed in vise as shown, cutter direction heading toward right.
SETTING THE CHAIN STOP
Put the chain in the vise (16).
Slide a chain cutter up against the chain stop (12).
Turn the adjustment knob (11) to position the
chain stop (12) laterally to the center of the cutter.
POSITIONING THE CUTTER
Rotate the locking pin (8) clockwise
to release the motor unit (A).
Move the grinding wheel onto the cutter
to be sharpened by pulling the motor
unit (A) downwards using handle (E).
16
16
12
11
12
8
A
B
E
PLACING CHAIN IN VISE