Operation Manual

ManualsBrandsOregon Scientific ManualsAir ConditioningBHR616

INTRODUCTION

Congratulations on purchasing the BHR616 Wireless Rain Guage.

Enclosed with this package is one (1) main display unit and one (1) remote

rain collector.

The rain gauge is equipped with the following features and functions:

- Daily and total rainfall display

- Nine-day rainfall recall history

- Easy wireless installation

FEATURES & KEY CONFIGURATION : MAIN

UNIT

WIRELESS RAIN GAUGE

MODEL: BHR616

USER’S MANUAL

Summary of content (9 pages)

PAGE 1
GB WIRELESS RAIN GAUGE MODEL: BHR616 USER’S MANUAL INTRODUCTION Congratulations on purchasing the BHR616 Wireless Rain Guage. Enclosed with this package is one (1) main display unit and one (1) remote rain collector.
PAGE 2
GB A. Upper Window - Displays the total rainfall, clock and date. B. RF Signal Indicator - Indicates the signal-receiving status of the unit C. Lower Window D. MODE/SET BUTTON - Displays the rainfall history - Switches between the clock and calendar in normal mode - Press and hold to enter the setting mode E. SINCE BUTTON - Displays the start day for total rainfall - Press and hold to clear the total and current rainfall and to reset the start date F.
PAGE 3
GB RAIN COLLECTOR: FEATURES a b a. Antenna b. Cross - To level the rain collector -Transmits signal to main unit BATTERY INSTALLATION: MAIN UNIT The main unit uses 2 UM-3 or AA alkaline batteries. 1. Unscrew the battery door at the bottom of the unit. 2. Remove the battery door and insert batteries in accordance with the polarities as indicated. 3. Select the display unit by the [IN/MM] switch. 4. Replace the battery door and fasten the screw.
PAGE 4
GB BATTERY INSTALLATION & SETTING UP: RAIN COLLECTOR The Rain Collector uses 2 UM-3 or AA alkaine batteries. 1. Remove the screws on the Rain collector as indicated in the diagram and insert the batteries in accordance with the polarities shown. 2. Remove the fiber tape from the Rain Collector assembly. 3. Position the main unit and rain collector within effective range of each other (up to 30 meters). 4. Place the rain collector on a level surface.
PAGE 5
GB LOW BATTERY WARNING There are two low-battery indicators [ ]. The indicator for the rain collection unit is shown as " [ ] out", and the indicator for the main unit is shown as [ ]. Replace the batteries immediately when the respective indicator lights up. Note : Every time the batteries in the main unit are changed, it is necessary to repeat installation steps 6 through 7 prior to use. SETTING THE CLOCK & CALENDAR 1. Press and hold the MODE/SET button for 2 seconds. 2.
PAGE 6
GB HOW TO READ THE RF SIGNAL INDICATOR The RF signal indicator shows the signal-receiving status of the main unit. There are three possible forms: The unit is in searching mode. Transmission data are securely registered. No signals. INTERRUPTED SIGNALS The success of wireless data transmission may vary and is directly related to the positioning of the remote rain collector and the environmental factors of that location.
PAGE 7
GB Wall-mounting: Wall mount bracket Connector: Use wall-mount connector to align with other wall-mount bracket if necessary. Wall Mount Connector Wall Mount Bracket CONNECTOR Un-install the brackets: MAINTENANCE When handled properly, this unit is engineered to give you years of satisfactory service. Here are a few product care instructions: 1. Do not immerse the unit in water. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. 2.
PAGE 8
GB 4. Do not tamper with the unit’s internal components. Doing so will terminate the unit’s warranty and may cause damage. The unit contains no user-serviceable parts. 5. Only use new batteries as specified in this instruction manual. Do not mix new and old batteries as the old batteries may leak. 6. Read this instruction manual thoroughly before operating the unit.
PAGE 9
GB R&TTE Compliance Note This device complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directive, if used for its intended use and that the following standard(s) has been applied: Electromagnetic compatibility (Article 3.1.b of the R&TTE Directive) Applied standards ETS 300 683 : 1997 Efficient use of the radio frequency spectrum (Article 3.