Owner's Manual
Table Of Contents
- Before starting the procedure
- Speaker Layout
- Speaker Installation
- Speaker Connections
- Connections
- Playback
- Playing audio from an externally connected device
- BLUETOOTH® Playback
- Listening To the Radio
- Listening Mode
- Quick Menu
- Spotify
- AirPlay®
- DTS Play-Fi®
- Amazon Alexa
- Amazon Music
- TIDAL
- Connecting the Sonos System for Playback
- Internet Radio
- Multi-zone
- Playing different audio and video
- Playing music files saved on a USB storage device
- Music Server
- Play Queue
- Connecting a transmitter for playback
- Setup
- Troubleshooting
- Appendix
160
Setup
3. Select "Next" and press ENTER. Then a test tone is output from each
speaker to conrm the connection. Selecting each speaker with the cursors
/ will output the test tone. Press ENTER after conrmation.
4. If there is no problem with the speaker connection, select "Next" and press
ENTER. To return to "Speaker Setup", select "Back to Speaker Setup" and
press ENTER.
2. Multi Zone Sound Check
Output test tones to ZONE 2 to enjoy audio in a separate room (ZONE 2) in
addition to the main room.
3. ARC Setup
If you have connected a TV that supports ARC, select "Yes" and press ENTER.
4. Room EQ
Measurements are performed to calibrate the sound eld to suit the room's
environment. When "Yes" is selected, you can choose between the "Dirac Live"
and "AccuEQ Room Calibration" methods of measurement in the "Dirac Live"
screen. Select "No, Later" if measurement is not to be performed. Note that both
measurement methods are also available after you have completed Initial Setup.
When measuring with Dirac Live
Download the Onkyo Controller to your mobile device and use the app to
operate the measurements. For details on how to measure with Dirac Live, refer
to "Measuring with Dirac Live" ( →p161).
When measuring with AccuEQ Room Calibration
Use the automatic sound eld calibration technology built into the unit. For
details on how to measure with AccuEQ Room Calibration, refer to "Measuring
with AccuEQ Room Calibration" ( →p163).
• Both measurement methods use the supplied speaker setup microphone.
• Each speaker outputs the test tone at high volume during measurement, so
be careful of your surroundings. Also, keep the room as quiet as possible
during measurement.
• If you connect a subwoofer, check the power and volume of the subwoofer.
Set the subwoofer volume to more than half.
• If the power of this unit suddenly turns off, the wires in the speaker cables
have touched the rear panel or other wires, and the protection circuit is
working. Twist the wires again securely, and make sure they do not stick out
of the speaker terminals when connecting.
• When using THX certied speakers, THX recommends that the crossover
frequency is set to "80Hz(THX)". Also, THX recommends that each speaker
setting is manually adjusted according to the specic characteristics of each
room.
The screen indicating that Initial Setup is complete is displayed when the
measurements are nished. Press ENTER while "Finished" is being displayed to
exit the Initial Setup.
Measuring with Dirac Live ( →p161)
Measuring with AccuEQ Room Calibration
( →p163)