Owner's Manual

11
REMOTE
CONTROL
RLRL
ININ
IN
IN
IN
COAXIA L
OPTICAL
IN
IN
IN
IN
FRONT
SURR
CENTER
SUB
WOOFER
VIDEO 2
VIDEO 1
OUT
IN
IN
OUT
OUT
OUT
DIGITAL INPUT
VIDEO 2VIDEO 3
VIDEO 1
DVD MONITOR
OUT
VIDEO
S VIDEO
DVD
TAPE
CD
FRONT
SPEAKERS A
FRONT
SPEAKERS B
L
R
IN
VIDEO 3
RL
SURROUND
SPEAKERS
CENTER
SPEAKER
L
R
AC OUTLET
ANTENNA
FM
75
AM
SUBWOOFER
PRE OUT
DIGITAL
OUT
S VIDEO
OUT
S VIDEO
IN
S VIDEO
OUT
VIDEO
OUT
AUDIO
OUT
VIDEO
IN
AUDIO
IN
RL RLLR
LR
VIDEO
OUT
AUDIO
OUT
VIDEO
OUT
AUDIO
OUT
LR
S VIDEO
OUT
VIDEO
OUT
FRONT
CENTER SUBWOOFER SURR
LR
AUDIO OUT
COAXIAL
DVD player or component
with 5.1 ch output (DVD)*
1
Video cassette player,
Satellite tuner, LD
player
*
5
, etc. (VIDEO 2)
VCR (VIDEO 1)
Audio/video
connection
cable
S video cable
(S video signal)
Audio (R)
Signal flow
S video plug
Coaxial cable
(Digital signal)
Coaxial plug
Connecting to audio/video equipment
*
1
If the DVD player has both 5.1 channel audio outputs and 2 channel audio outputs, and you want to connect the DVD player only using
the FRONT L/R jacks on the HT-R420, use the 2 channel audio output jacks on the DVD player.
If the DVD player only has the 2 channel audio outputs, connect it to the FRONT L/R jacks.
*
2
To connect the digital output from DVD player connected to the DVD jacks to this unit, use the COAXIAL input jack.
To connect the digital output to the OPTICAL input jack of this unit, it is required to change the assignment of digital inputs to input
sources by referring to “Setting the digital inputs” on page 21.
*
3
Be sure to make the same video connection (either S-VIDEO or standard VIDEO) between your component(s), the receiver, and your TV.
*
4
VIDEO3 does not have an S VIDEO terminal. Therefore, check that the TV connected to MONITOR OUT is also connected to the
VIDEO terminal.
*
5
If you have an LD player with AC-3RF output, connect via an AC-3RF demodulator to one of the HT-R420’s DIGITAL INPUT
terminals.
Audio (L)
Video
Caution
Make sure that the capacity of the other components connected
to this unit does not exceed the capacity that is printed on the
rear panel (ex. 120 watts).
To connect the digital
output from satellite
tuner etc. connected to
the VIDEO 1, VIDEO 2
or VIDEO 3 jacks to the
COAXIAL or OPTICAL
input jack of this unit, it is
required to change the
assignment of digital
inputs to input sources by
referring to “Setting the
digital inputs” on page
21.
DO NOT connect the
power cord at this
time.
*
3
*
3
*
3
Video Camera,
Game Device, etc.
(VIDEO 3)
*
4
*
2